HPE6-A29 Exam Questions
346 real HPE6-A29 exam questions with expert-verified answers and explanations. Page 5 of 7.
- Question #205
Other than a user role, what attribute can be applied to a user with a derivation rule?
- Question #206
Which is an Aruba specific DSA that can be used in a user derivation rule?
- Question #207
Where are Aruba Vendor Specific Attributes (VSA) programmed?
- Question #208
A customer has configured a 3000 controller with the following commands: Vlan 55 Vlan 56 Vlan 57 Interface gigabitethernet 1/0 switchport mode trunk switchport trunk native vlan 55...
- Question #209
What cannot be configured from the Initial Configuration wizards?
- Question #210
When you create a WLAN SSID in the WLAN/LAN wizard what AP group is it automatically added to?
- Question #211
The reusable wizards are accessible in which one of the following ways?
- Question #212
What additional fields must be configured in the configuration wizard if the controller role is selected as a local instead of a standalone controller?
- Question #213
When configuring ports in the configuration wizard, which of the following are not options for configuration?
- Question #214
What Wizards can be used to create a new AP Group?
- Question #215
Which of the following functions cannot be done in the offline Visual RF plan?
- Question #216
The Aruba controller's Command Line Interface can be accessed from WITHIN the browser based Web User Interface using which method?
- Question #217
Which tunnel protocol is used between controllers to support L2 mobility in an Aruba environment?
- Question #218
When roaming, by default which device will decide when to handoff / move to another AP?
- Question #219
Which of the following charts are available for selection in Spectrum Dashboard for AP 125?
- Question #220
How can a role be assigned to a user, connected to an untrusted port, on a controller?
- Question #221
When APs boot up, in which order do they discover a controller?
- Question #222
An AP resolved DNS and found the master controller. How will this AP be redirected to a Local controller?
- Question #223
A 3200 controller has 32 PEF-NG license, 16 RFProtect license and 32 AP licenses, how many AP's can terminate on the controller?
- Question #224
Which is the default management VLAN on an Aruba switch?
- Question #225
Which set of configuration commands are needed to make VLAN 10 the management VLAN?
- Question #226
Which parameter does a Master switch use to determine where a provisioned AP should terminate its GRE tunnel?
- Question #227
Which of the following configurations can accept a vlan pool?
- Question #228
Which feature must be enabled for self-healing to be performed?
- Question #229
What does Aruba's RF self-healing require to operate?
- Question #230
In Visual RF, Floor plans can be imported in what format?
- Question #231
Referring to the diagram provided for this question, if the Aruba controller is configured to perform L3 switching, what will be the wireless user's default gateway?
- Question #232
Which of the following statements is not true about the remote node?
- Question #233
Two Aruba 620 controllers are configured as a VRRP pair. One of the controllers fails. Which is the maximum number of campus APs that the remaining controller can terminate?
- Question #234
For controller redundancy to work and support failover of access points, to which IP address should the Aruba AP terminate its GRE tunnel?
- Question #235
A Master switch can serve as an AP backup for a local switch.
- Question #236
Referring to the diagram provided for this question, an employee brought an unauthorized AP from home and attached the LAN port to the cubicle Ethernet port. All Aruba APs and AMs...
- Question #237
What can an AM do that an AP cannot do?
- Question #238
Which of the following functions cannot be configured in the WIPS wizard?
- Question #239
Referring to the screen captures provided for this question, what can you conclude about the two clients from the Packet Rate Distribution screens?
- Question #240
Referring to the above screen capture, which tab tells you which licenses are installed on the controller?
- Question #241
If a Remote AP (RAP) is attempting to contact a controller that is behind a NAT device what protocol must be allowed through the NAT/Firewall?
- Question #242
Which of the following are valid RAP forwarding modes (select all that apply)?
- Question #243
When does a backup SSID configured on a Remote AP (RAP) begin broadcasting?
- Question #244
A Remote AP provisioned with an SSID in the operational mode "always" has which one of the following characteristics?
- Question #245
What is the purpose of Mesh Clusters?
- Question #246
When deploying Remote Mesh Portals, what is one of the purposes of the Mesh Private VLAN?
- Question #247
A network administrator runs a 'show ap mesh topology' command on an Aruba 620 controller. Which of the following information would he be able to obtain? Choose all that apply.
- Question #248
How does Aruba's infrastructure calculate location?
- Question #249
You want to locate a wireless device on the controller GUI. You go to the Clients list from the Monitoring tab and click the Locate button but the controller is unable to locate th...
- Question #250
Which of the following needs to be done prior to attempting to use the GUI quick setup of a factory defaulted Aruba S3500 Mobility Access Switch?
- Question #251
Which two factors are important when choosing a controller model to support tunneled node?
- Question #252
In tunneled node configuration the Aruba 3500 mobility access switch acts as a?
- Question #253
With Visual RF location tracking, show location history can be set for a maximum of?
- Question #254
An Aruba controller can be configured to support which CLI based remote access methods?