HPE6-A29 Exam Questions
346 real HPE6-A29 exam questions with expert-verified answers and explanations. Page 2 of 7.
- Question #51
The screen captures above show the 802.1X authentication profile and AAA profile settings for a VAP. If machine authentication passes and user authentication fails, which role will...
- Question #52
Referring to the above screen capture, if an administrator desires to change a specific AP into a Spectrum Monitor without assigning the AP to a new group, which menus could be use...
- Question #53
An Aruba controller can be accessed with which CLI based remote access methods?(Choose two)
- Question #54
In the above screen capture, the administrator notes that most of the configuration options are grayed out and have no action. What is the cause of the problem?
- Question #55
Referring to the above screen capture, on which controller can you modify APs configuration to enable ARM?
- Question #56
Which of the following metrics does the ARM feature use to calculate the optimal channel and power level for Access Points? (Choose two)
- Question #57
When direct consoled to an AP, what is the command sequence to factory default the AP and re- bootstrap?
- Question #58
Which of the following will accept named VLANs as a parameter? (Choose three)
- Question #59
An administrator is setting up a factory default controller. No new AP groups were created. When adding a WLAN SSID in the Campus WLAN wizard what AP group is available?
- Question #60
The reusable Aruba Controller wizards are accessible in what way?
- Question #61
When an 802.11 client roams what device decides when to move the client to another AP?
- Question #62
A customer has a remote AP deployment, where each remote AP has an IPSEC VPN tunnel with L2TP to the controller. 1 of the remote APs is stuck in the user table and hasn't yet trans...
- Question #63
A client Roams from one Local controller-1 to another Local controller-2. The controllers are in different subnets and L3 Mobility is enabled. How is the client traffic sent back t...
- Question #64
Which of the following statements is true of Spectrum Mode?
- Question #65
The screen captures above show the 802.1X authentication profile and AAA profile settings for a VAP. If machine authentication fails and user authentication passes, which role will...
- Question #66
Referring to the above screen capture, on which controller can you add an administrative user and assign a controller management role?
- Question #67
Which command will show all client association history?
- Question #68
What is the total number of charts you can simultaneously monitor in a spectrum dashboard?
- Question #69
Which is a Device Specific Attribute that can be evaluated in a user derivation rule?
- Question #70
The Controller wizard enables which of the following controller clock configurations?(Choose three)
- Question #71
What is the function of Band Steering?
- Question #72
With CPSec disabled, which tunnel protocol is used between APs and Controllers in an Aruba environment?
- Question #73
The above diagram has one master and three local controllers. AP1 GRE terminates on controller Local 1. All controllers are configured with the wireless user VLAN 201. A wireless u...
- Question #74
The screen captures above show the 802.1X authentication profile and AAA profile settings for a VAP. If machine authentication fails and user authentication fails, which role will...
- Question #75
Masters communicate configuration information with locals using which tunnel type?
- Question #76
Which of these are NOT a client attribute that can be configured in user derivation rules?
- Question #77
Aruba Client Match does NOT use which of the following parameters to determine the best AP for a client connection?
- Question #78
Refer to the above screen capture. By default, which controller's internal database will be used for user authentication?
- Question #79
What is true about an AP in Hybrid Spectrum mode?
- Question #80
A Server Group has been configured with three Radius servers. Load balancing has been enabled. Choose the correct statement?
- Question #81
Which parameter(s) does a Master controller use to determine where a provisioned AP should terminate its GRE tunnel?
- Question #82
A port firewall policy is applied to a trunk port that denies controller access. An "allow all" VLAN firewall policy is applied to VLAN 33 on the same port. A user connected to VLA...
- Question #83
In a master-local controller scenario, where is the mobility domain defined?
- Question #84
How is an AP redirected to a Local controller after DNS resolution returns the Master's IP address?
- Question #85
An AP is not communicating with the controller. Upon investigation you find that the AP is not discovering its controller through DNS. Instead, it received a DHCP reply with option...
- Question #86
Referring to the diagram provided for this question, if the Aruba controller is configured to perform L3 switching, what will be the wireless client laptop default gateway?
- Question #87
Fast Failover has been implemented between Local 1 and Local 2 separated by Routers. During testing Local1 was disabled and all Campus APs backed up to Local 2 flawlessly. But the...
- Question #88
As illustrated in the above diagram, a company has two campus locations and a building headquarters all located in different cities. Following best practices, what would be the bes...
- Question #89
When APs boot up, in which order do they Select a controller?
- Question #90
Screenshots of the Captive Portal authentication profile and server group of a guest network are displayed above. How was the user authenticated?
- Question #91
With Fast-Failover disabled, to which IP address should the Aruba AP terminate its GRE tunnel for layer 2 controller redundancy to work and to support failover of access points?
- Question #92
Where should mobility domains be enabled in a network with 1 master, 1 backup master and 5 local controllers ?
- Question #93
An AP was configured to use dynamic controller discovery and assigned to an AP group, then powered off for over a week. When the AP is redeployed, what previous configuration will...
- Question #94
In the diagram provided for this question, the Aruba controller terminates one end of a GRE tunnel that carries wireless user traffic. Where does the other end terminate?
- Question #95
Which of the following configurations can accept a VLAN pool?(Choose two)
- Question #96
A user logged in with the Captive Portal settings shown in the above screen capture. What does the user need to do to logout?
- Question #97
A port on a controller has been configured as untrusted. No wired access AAA profile or Global AAA profile is configured. When a user connects to that port which of the following s...
- Question #98
What are two different methods of configuring AP redundancy between 2 local controllers?(Choose two.)
- Question #99
In the above diagram, the system shows two Aruba access points. Which VLANs must be configured on trunk link D between the router and Aruba controller to support wireless users whe...
- Question #100
Referring to the diagram provided for this question, in which locations must you define the new data VLANs for wireless client traffic? (Choose two)