HP
HPE0-S60 · Question #46
Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer…
The correct answer is B. FC connectivity on the modules should be enabled through the service console by disabling FCoE. See the full explanation below for the reasoning.
Question
Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocol. What must be done to complete this task?
Options
- AEnable FC primary and secondary boot on the modules through the HPE OneView interface
- BFC connectivity on the modules should be enabled through the service console by disabling FCoE.
- CAdd FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules
- DEnter both modules into a maintenance mode, then enable FC connectivity through CLI
How the community answered
(23 responses)- A9% (2)
- B83% (19)
- C4% (1)
- D4% (1)
Community Discussion
No community discussion yet for this question.