HP2-Z37 Exam Questions
130 real HP2-Z37 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #104
Which HP ProVision switch command defines 10.1.1.1 as a syslog server?
- Question #105
Which statement is true about wireless technologies?
- Question #107
Refer to the network exhibit. A network administrator has created a Layer 2 network based on the design shown in the exhibit. Switch-A and Switch-B are distribution layer switches....
- Question #108
A network administrator configures this command on an HP ProVision Switch: Vlan 30 ip helper-address 10.0.3.253 After the network administrator configures the command, using in VLA...
- Question #109
Which parameter is enabled by default on an HP Commware switch, but disabled by default on an HP ProVision switch?
- Question #110
A routing protocol has three characteristics: - Has fast convergence with triggered,incremental updates via link stateadvertisements(LSAs) - Is classlessprotocol allowing for ahier...
- Question #111
A network administrator has set up a link between two HP ProVision switches. Both switches have an IP address in VLAN 1 and can ping each other in VLAN 1.The network administrator...
- Question #112
Which Intelligent Management center (IMC) module implements policies for environments that support brings your own device (BYOD)?
- Question #113
Which statement is true concerning PoE support on HP ProVision and HP Comware switches?
- Question #114
Refer to the HP Comware configuration. interface vlan 1 ip address 10.1.1.1 255.255.255.0 quit interface vlan 2 ip address 10.1.2.1 255.255.255.0 quit interface loopback 1 ip addre...
- Question #115
A network administrator has a server with a single link to the network. The company is concerned about redundancy and wants to implement a solution like that shown in the right-han...
- Question #116
Refer to the topology output. Based on this topology, which statements are true? (Select two)
- Question #117
A network administrator has an HP Comware switch that is configured with OSPF. The network administrator views the routing table and sees that a default route was learned from an O...
- Question #118
A network administrator is building two IRF domains: - One domain for the two distribution layer switches - One domain for the access layer switches Each access layer switch should...
- Question #119
Which IMC agent starts and stops the IMC server and allows a network administrator to view the status of the IMC processes?
- Question #120
What are the default logging properties for an HP Comware switch? (Select two)
- Question #121
What is the default state of spanning tree on HP Comware switches?
- Question #122
A network administrator executes the following command: What is the state of the VLAN 1 interface?
- Question #123
Refer to the network exhibit. The network shown in the exhibit is comprised of four MSTP regions that are interconnected. Based on this topology, which statement is true?
- Question #124
A network administrator is expanding part of the data center in a hospital network. Three new racks of equipment need to be added, with an HP Comware 5820 series switch at the top...
- Question #125
Switch 1 and Switch 2 are HP ProVision switches operating as Layer 2 switches. VLAN 33 has been defined as the management VLAN on both switches. Based on this topology, which user...
- Question #126
A network administrator has installed IMC and the appropriate licenses. The network administrator is attempting to import the HP Comware and HP ProVision switches into IMC but is e...
- Question #127
A device is connected to an HP Comware hybrid port. Which type of information from the attached device can be used to assign it to a VLAN?
- Question #128
What is the initial OSPF state of a router when an interface becomes active for a segment?
- Question #129
The external server shown in the exhibit requires redundancy that uses link aggregation with LACP. Which solution meets this criteria?
- Question #130
A network administrator is using Intelligent Management Center (IMC). Which protocol must the network administrator configure to correctly identify HP devices when performing auto...
- Question #131
After setting up DHCP relay, the network administrator has the DHCP client try to acquire addressing information, but the process fails. What should the network administrator do to...
- Question #132
Which trends of today's data center networks is the HP FlexNetwork Architecture designed to meet?
- Question #133
A network administrator has two distribution layer switches and four access layer switches. The network administrator is constantly resolving Spanning Tree problems and is looking...
- Question #134
Which statement is true about the management of HP ProVision and Comware switches?