HP
HP2-Z12 · Question #7
You are installing a redundant power supply in an HP E8212 zl switch. Which procedures are recommended when installing the new power supply?(Select two.)
The correct answer is B. Attach the new power supply to a different AC power source than the existing power supply to C. Tighten the retaining screws on the new power supply until they are snug but not over- tight. See the full explanation below for the reasoning.
Question
You are installing a redundant power supply in an HP E8212 zl switch. Which procedures are recommended when installing the new power supply?(Select two.)
Options
- ARemove the copper RFI shielding.
- BAttach the new power supply to a different AC power source than the existing power supply to
- CTighten the retaining screws on the new power supply until they are snug but not over- tight.
- DConnect the redundant power supply to the AC power source before installing it in the switch.
- ERemove the grounding tap from the console port before installing the power supply.
How the community answered
(30 responses)- A7% (2)
- B70% (21)
- D13% (4)
- E10% (3)
Community Discussion
No community discussion yet for this question.