LEDs on the HP E8200 zl switch and HP E5400 zl switch can provide what information about an installed HP E-MSM765 zl Mobility Controller?

Question

Options

• AThere is network activity on one or both E-MSM765 zl ports.
• BThe E-MSM765 zl's hard disk drive has not initialized.
• CThe E-MSM765 zl's compact flash has not initialized.
• DThe E-MSM765 zl passed its self-test

• A
  3% (1)
• B
  7% (2)
• C
  17% (5)
• D
  72% (21)

Explanation

There are also a number of LEDs on the HP E8200 zl Series and HP E5400 zl Series switches that monitor the status of the E-MSM765 zl. These LEDS are related to the module's self test , which takes place both when the switch is powered on after the module is installed in the chassis, and when the E-MSM765 zl is installed while the switch already has power. The following LEDs on the switch help determine if the E-MSM765 zl has passed the self test: Test LED--This is on briefly while the module is undergoing the self test, and then goes off. (Note: If the EMSM765 zl was installed with the switch powered off, and then the switch was powered on, the Test LED will stay on for the duration of the self test.) Fault LED--This LED is off if the E-MSM765 zl installed properly. Module Status LED--This LED goes on as soon as the E- MSM765 zl is installed and the switch is powered on. It stays on.

No community discussion yet for this question.