HP
HP0-Y52 · Question #55
Refer to the exhibit. The switches in the exhibit are all HP Comware switches that run Multiple Spanning Tree Protocol (MSTP). The network administrator wants to ensure that each switch-to-switch…
The correct answer is A. Configure them as trunk ports that permit VLANs 10 and 20. See the full explanation below for the reasoning.
Question
Refer to the exhibit. The switches in the exhibit are all HP Comware switches that run Multiple Spanning Tree Protocol (MSTP). The network administrator wants to ensure that each switch-to-switch link is in its own subnet. The administrator also wants to make sure that all of the links are available for routing during normal operation. How should the administrator configure the physical switch-to-switch interfaces to accomplish these goals?
Exhibit
Options
- AConfigure them as trunk ports that permit VLANs 10 and 20.
- BConfigure them as any type of port, and make sure spanning tree is enabled on them.
- CConfigure them as route-mode ports.
- DConfigure them as hybrid ports that carry VLAN 10 and 20 as untagged.
How the community answered
(64 responses)- A75% (48)
- B16% (10)
- C6% (4)
- D3% (2)
Community Discussion
No community discussion yet for this question.