HP
HP0-Y50 · Question #133
Refer to the exhibit. All switch interfaces shown in the exhibit have these characteristics: Are configured in routed-mode Have IP addresses Run Open Shortest Path First (OSPF) Network architect…
The correct answer is C. Set the OSPR reference bandwidth on the routing switches to an appropriate level, such as 100000. See the full explanation below for the reasoning.
Question
Refer to the exhibit. All switch interfaces shown in the exhibit have these characteristics:
Are configured in routed-mode Have IP addresses Run Open Shortest Path First (OSPF) Network architect wants to ensure that routing switch 1 uses the faster link in preference to the slower link, which should be used in failover situations. Which step should be architect perform to meet this requirement?
Exhibit
Options
- ADisable ECMP on Routing switch 1 and on other routing switches for consistency.
- BSet the designated router preference on Routing switch 2 interface Forty1/0/48 to a lower level than on
- CSet the OSPR reference bandwidth on the routing switches to an appropriate level, such as 100000
- DConfigure Routing switch 1 interface Ten1/0/1:1 as a silent, or a passive, OSPF interface.
How the community answered
(29 responses)- A10% (3)
- B3% (1)
- C83% (24)
- D3% (1)
Community Discussion
No community discussion yet for this question.