HP
HP0-Y49 · Question #41
A network administrator attempts to create a loopback interface on an HP Comware switch, and it fails. These are the commands the network administrator issues to do this. [Comware] interface…
The correct answer is D. Loopback interface on Comware must use32-bit marks. See the full explanation below for the reasoning.
Question
A network administrator attempts to create a loopback interface on an HP Comware switch, and it fails. These are the commands the network administrator issues to do this. [Comware] interface loopback 2 [Comware-Loopback2] ip address 172.18.20.1 255.255.255.0 What is the problem with the proposed configuration/
Options
- AOnly HP ProVision switches support loopback interface
- BLoopback IP addresses must be in the 10.x.x.x subnet ranges
- COnly one loopback is supported in Comware Loopback2 cannot be configured
- DLoopback interface on Comware must use32-bit marks
How the community answered
(43 responses)- A9% (4)
- B2% (1)
- C5% (2)
- D84% (36)
Community Discussion
No community discussion yet for this question.