HP
HP0-Y47 · Question #58
Refer to the exhibit. A server connects to GigabitEthernet1/0/1 on an HP Comware switch. The server sends tagged traffic in VLAN2. It has an application that sets the DiffServ Code Point (DSCP) for…
The correct answer is C. Change the dot1p-lp map to map 802.1p value 2 to lp 2 and 802.1p value 0 to lp1. Change the dscp-dot1p map to map DSCP 16 to 802.1p value 1. RECEIBE priority 0. See the full explanation below for the reasoning.
Question
Refer to the exhibit. A server connects to GigabitEthernet1/0/1 on an HP Comware switch. The server sends tagged traffic in VLAN2. It has an application that sets the DiffServ Code Point (DSCP) for its traffic to 16 and the 802.1p value to 2. The switch should use the DSCP to place the traffic in priority queue. The traffic belongs to the queue that is one priority level higher than the queue for best effort traffic (traffic without a QoS value). What can the network architect do to meet this requirement?
Options
- AChange GigabitEthernet1/0/1's trust setting to "dot1p" set the port priority to 3. DSCP will not be used
- BKeep GigabitEthernet1/0/1's QoS trust setting to "dot1p" Set the port priority to 3.
- CChange the dot1p-lp map to map 802.1p value 2 to lp 2 and 802.1p value 0 to lp1. Change the dscp-dot1p map to map DSCP 16 to 802.1p value 1. RECEIBE priority 0
- DChange the dscp-dot1p map to map DSCP 16 to 802.1p value 1. RECEIBE priority 0
How the community answered
(36 responses)- A6% (2)
- B3% (1)
- C81% (29)
- D11% (4)
Community Discussion
No community discussion yet for this question.