HP
HP0-Y37 · Question #59
A company is replacing two Cisco switches at the distribution layer with two HP E6200 yl Series switches. You have begun the migration by connecting one of the new HP E-Series switches to the…
The correct answer is A. Migrate the Cisco switches to OSPF only and enable OSPF on VLANs 1, 2, 20, and 111 on the Cisco distribution switch. See the full explanation below for the reasoning.
Question
A company is replacing two Cisco switches at the distribution layer with two HP E6200 yl Series switches. You have begun the migration by connecting one of the new HP E-Series switches to the existing network in parallel. The first exhibit displays the network topology at the point in the migration. The Cisco distribution switch is running EIGRP and HSRP. The Cisco core switch runs EIGRP and OSPF, and the HP E-Series switch runs OSPF and VRRP. The edge switches and endpoints on VLANs 1, 2, 20, and 20 use 10.1.X.254 as their default gateway address (X being their VLAN ID). You will also disable VLAN 10 on the Cisco distribution switch and enable VRRP on VLAN 10 on the HP E-Series switch. But to avoid connectivity issues for some endpoints, you need to change your configuration first.What are two ways you can configure the distribution switches? (Select two.)
Options
- AMigrate the Cisco switches to OSPF only and enable OSPF on VLANs 1, 2, 20, and 111 on the Cisco distribution switch.
- BChange the virtual IP address on the E-Series switch to a different address such as 10.1.10.253/24.
- CChange the virtual 10 IP address on the Cisco distribution switch to a different address such as 10.1.10.253/24 before disabling the interface.
- DConfigure a default route to 10.1.1.1/24 on the HP E-Series switch.
- EConfigure a default route on the Cisco distribution switch to a routing switch at the core.
How the community answered
(21 responses)- A81% (17)
- B5% (1)
- D5% (1)
- E10% (2)
Community Discussion
No community discussion yet for this question.