HP
HP0-Y37 · Question #53
You are installing a new HP, A-Series switch to an existing Cisco network running the following VLANS: management (VLAN id 1), sales (VLAN id 2), engineering (VLAN id 3), HR (VLAN id 4). Cisco#…
The correct answer is D. Cisco(config-if)#switchport trunk native vlan 3. See the full explanation below for the reasoning.
Question
You are installing a new HP, A-Series switch to an existing Cisco network running the following VLANS: management (VLAN id 1), sales (VLAN id 2), engineering (VLAN id 3), HR (VLAN id 4).
Cisco#
interface GigabitEthernet1/0/23
switchport trunk encapsulation dot1q
switchport mode trunk
[HP]
interface GigabitEthernet1/0/24
port link-type trunk
port trunk pvid vlan 3
Engineering users connected to an HP switch are complaining that they are unable to access engineering resources connected to the Cisco switch?Which configuration change will correct this problem?
Options
- ACisco(config-if)#switchport trunk allowed vlan all
- B[HP]GigabitEthernet1/0/24port trunk pvid vlan 2
- C[HP]GigabitEthernet1/0/24port trunk permit vlan all
- DCisco(config-if)#switchport trunk native vlan 3
How the community answered
(29 responses)- A7% (2)
- B10% (3)
- C3% (1)
- D79% (23)
Community Discussion
No community discussion yet for this question.