Under the H.248 protocol, if the signaling IP and media IP are both 10.1.1.100/8 and the voice gateway is 10.1.1.1, when configuring the voIP service, which of the following commands is wrong?

Question

Options

• AUse the command ip address media 10.1.1.100 10.1.1.1 to configure the media IP in voip mode
• BUse the reset cold start command under the voice interface to make the interface attribute
• CUse the if-h248 attributei command to configure interface attributes under the voice interface
• DUse the command ip address signaling 10.1.1.100 10.1.1.1 in voip mode to configure the signaling

• A
  7% (2)
• B
  14% (4)
• C
  3% (1)
• D
  76% (22)

No community discussion yet for this question.