Huawei
H35-210_V2.5 · Question #294
When other SNMP parameters are configured correctly, how to configure the trap source address of the device to ensure that the network manager can receive device alarms normally?
The correct answer is C. The trap source address is set to the address used by the network manager to add the device. See the full explanation below for the reasoning.
Huawei Access Network Products
Question
When other SNMP parameters are configured correctly, how to configure the trap source address of the device to ensure that the network manager can receive device alarms normally?
Options
- AThe trap source address is set to 127.0.0.1
- BThe trap source address is set to the loopback address
- CThe trap source address is set to the address used by the network manager to add the device
- DAll of the above.
How the community answered
(52 responses)- A4% (2)
- B10% (5)
- C83% (43)
- D4% (2)
Topics
#SNMP#trap source address#network management#alarm configuration
Community Discussion
No community discussion yet for this question.