H31-311_V2.5 Exam Questions
702 real H31-311_V2.5 exam questions with expert-verified answers and explanations. Page 9 of 15.
- Question #401
The outer electrons of the bait ion have a three-level structure, among which the metastable energy level is which of the following?
- Question #402
The OptiXtrans DC908 chassis is only equipped with 1 sCc board and 1 PANEL board and cannot be configured as 1+1 dual master control.
- Question #403
The LOI low-level interface includes multiple logical function blocks. Which of the following does not belong to the function blocks in the LOI low-level interface?
- Question #404
The correct statement about the multiplex section remote error indication MS-REI is (): 1. B2 byte is the transmission channel; 2. M1 byte is the transmission channel; 3. sent back...
- Question #405
Which of the following descriptions about signal marker byte C2 is wrong?
- Question #406
Which of the following media types has a transmission distance of no more than 1 km?
- Question #407
Which of the following descriptions about the TNG2M 402D board is wrong?
- Question #408
According to the OTU board naming rules, which of the following descriptions of the letters in the MS04 board is wrong?
- Question #409
Which of the following is not an advantage of EDFA?
- Question #410
Which logical function block generates the R-LOS alarm?
- Question #411
The segment overhead of STM-4 is 9*9*4 bytes/frame.
- Question #412
Which of the following descriptions about the PANEL panel on Optixtrans D908 is wrong?
- Question #413
Which subtype of tributary SNCP protection requires no electrical relay station in the subnet along which the ODUk signal passes?
- Question #414
Which of the following descriptions of OTM-nm and OTM-nr.m optical layer interfaces of OTN is wrong?
- Question #415
Among the following modulation technologies, which one performs best in terms of wavelength stability?
- Question #416
Which is the basic requirement of DWDM system for light source?
- Question #417
The refractive index of the core n1 ( ) cladding refractive index n2, which is a necessary condition for the transmission of optical signals in optical fibers.
- Question #418
Which of the following communication protocols does Huawei equipment not support for DCN networking?
- Question #419
How many frames is the minimum interval between two adjacent pointer adjustment events?
- Question #420
Which of the following is the switching point of linear multiplex segment protection?
- Question #421
Which new unit is added to Liquid OTN?
- Question #422
Which unit is newly added in Liquid OTN?
- Question #423
FOADM includes parallel FOADM and serial FOADM, both of which support any wavelength up to 40 wavelengths or 80 wavelengths.
- Question #424
Self-healing means that when a network failure occurs, the network automatically recovers from the failure in a very short time (ITU-T stipulates that it is within ()) without huma...
- Question #425
In the Colored & Directed scenario of 4D ROADM, how many sets of M40V+D40 are needed to dispatch local services to four directions?
- Question #426
Which of the following descriptions about overhead bytes is wrong?
- Question #427
Which of the following is not an advantage of SDH?
- Question #428
How many management unit pointers are there in the STM-64 frame structure?
- Question #429
Which of the following descriptions about the MD02 board is wrong?
- Question #430
If the overhead bytes pass through the backplane bus between two slots, the two slots are called paired slots. Paired slots enable automatic transparent transmission of overhead by...
- Question #431
Which of the following alarm/event dump modes does U2000 support? (Multiple choice)
- Question #432
SDH signals must be scrambled before transmission over optical fiber. Which of the following bytes is not scrambled? (Multiple choice)
- Question #433
Erbium-doped fiber amplifier (EDFA) is a key component of the new generation of optical communication systems. Which of the following is the function of EDFA? (Multiple choice)
- Question #434
Which of the following statements about the EFS4 circuit board are correct? (Multiple choice)
- Question #435
Which of the following are device-level protection solutions for SDH products? (Multiple choice)
- Question #436
In the case of 1+1 linear MSP, which of the following switching modes does not require the APS protection protocol to be enabled? (Multiple choice)
- Question #437
Which of the following are the basic functions of U2000? (Multiple choice)
- Question #438
After configuring PDH services on a per-network element basis, a complete trace cannot be searched. Which of the following is a possible reason? (Multiple choice)
- Question #439
Which of the following logic function modules involve processing clock signals? (Multiple choice)
- Question #440
Which of the following is a step to multiplex low-speed services into high-speed SDH services? (Multiple choice)
- Question #441
For a (local) HA solution where the active and standby servers are deployed at the same location, which of the following platforms can be deployed? (Multiple choice)
- Question #442
Which of the following can be used as the central wavelength of the pump source in EDFA? (Multiple choice)
- Question #443
Which of the following different types of ESC are classified according to implementation principles? (Multiple choice)
- Question #444
In the system control unit, which of the following databases will not lose data after a power failure? (Multiple choice)
- Question #445
Which of the following statements about basic LCAS functions are correct? (Multiple choice)
- Question #446
Which of the following are components of a WDM system that multiplexes N wavelengths? (Multiple choice)
- Question #447
Which of the following options are low-loss areas of single-mode optical fiber? (Multiple choice)
- Question #448
Which of the following steps are generally required to multiplex low-speed services into high- speed SDH services? (Multiple choice)
- Question #449
What are the main advantages of WDM? (Multiple choice)
- Question #450
Compared with traditional SDH and SONET equipment, which of the following advantages does OTN have? (Multiple choice)