H13-629_V3.0 · Question #254
An engineer went to a customer unit to install Huawei OceanStor 9000 equipment (a total of 5 Huawei OceanStor9000 C Nodes, both the front and back ends are 10GETOE networking, and TOE network cards…
The correct answer is B. The signal cable with label "NODEO1A0-O" is plugged into the network port position A0-1, and the D. The 5 devices have both TOE network card insertion positions AO, B1 and AO, B3. Since they are. See the full explanation below for the reasoning.
Question
An engineer went to a customer unit to install Huawei OceanStor 9000 equipment (a total of 5 Huawei OceanStor9000 C Nodes, both the front and back ends are 10GETOE networking, and TOE network cards are installed on site). The equipment has been put on the shelf. Next, the signal cable and power cable will be connected, and the software will be debugged. Due to the tight schedule, the following phenomena occurred during the hardware installation process. Which of the following descriptions of these phenomena do you think is wrong? (Multiple choice)
Options
- AThe CE6850 switch is connected to two stacking copper cables. One of the cables is faulty and
- BThe signal cable with label "NODEO1A0-O" is plugged into the network port position A0-1, and the
- CIn order to manage each Node separately, all Nodes must connect their NICo ports to the
- DThe 5 devices have both TOE network card insertion positions AO, B1 and AO, B3. Since they are
How the community answered
(45 responses)- A7% (3)
- B80% (36)
- C13% (6)
Topics
Community Discussion
No community discussion yet for this question.