H12-831_V1.0 · Question #274
The network logical architecture of a cutover project is shown in the figure. The purpose of the cutover is to enable terminals located in different geographical locations to access each other, and…
The correct answer is A. Deploy NQA detection on PE1 and PE2, and set the destination address to the other party's IP C. Ping 192.168.2.1 on PE1 using 192.168.1.1 as the source address D. Check whether there is a route to the other network segment in the routing table on PE1 and PE2. See the full explanation below for the reasoning.
Question
The network logical architecture of a cutover project is shown in the figure. The purpose of the cutover is to enable terminals located in different geographical locations to access each other, and the terminal gateway is deployed on the PE. After the cutover is completed, which of the following methods can network engineers use to preliminarily determine whether the network connectivity is normal? (Multiple choice)
Exhibit
Options
- ADeploy NQA detection on PE1 and PE2, and set the destination address to the other party's IP
- BCheck the ARP table on PE1 and PE2 to see if there is an ARP entry for the other network
- CPing 192.168.2.1 on PE1 using 192.168.1.1 as the source address
- DCheck whether there is a route to the other network segment in the routing table on PE1 and PE2.
How the community answered
(28 responses)- A71% (20)
- B29% (8)
Community Discussion
No community discussion yet for this question.