H12-821_V1.0 Exam Questions
1,196 real H12-821_V1.0 exam questions with expert-verified answers and explanations. Page 4 of 24.
- Question #151IPv4 Routing Technologies
The output information of a router is below, which is correct about this information?
BGPMED attributeroute selectionoptimal route - Question #152IPv4 Routing Technologies
The multicast destination address of the VRRP message is?
VRRPmulticast addressgateway redundancy - Question #153IPv4 Routing Technologies
A certain router runs IS-IS, and its output information is shown in the figure. Which of the following statements is correct?
IS-IScircuit levelinterface costIIH timer - Question #154IPv4 Routing Technologies
Four routers run IS-IS and have established adjacency relationships. The area numbers and router levels are marked in the figure. What is the Cost value for R4 to reach 10.0.2.2/32...
IS-ISroute costinter-area routingL1/L2 boundary - Question #155IPv4 Routing Technologies
The four routers run IS-IS and have established an adjacency relationship. The area numbers and router levels are marked in the figure. What is the cost of R4 reaching 10.0.2.2/32?
IS-ISpath cost calculationLevel-2 routingarea topology - Question #156IPv4 Routing Technologies
The four routers run IS-IS and have established adjacency. The area numbers and router levels are shown in the figure. Which of the following is correct?
IS-ISLSDBLSP floodingarea boundary - Question #157Network Security
Based on this packet, which of the following is correct?
IPsecAH headerprotocol number 51VPN - Question #158Network Security
As shown in the figure below, the firewall receives a message from PC1 to PC2, which of the following statements is correct?
firewallsecurity policytraffic matchingdefault deny - Question #159IPv4 Routing Technologies
The following is the output information of a router. Which of the following statements is correct?
BGPcommunity attributeno-advertiseno-export - Question #160Layer 2 Technologies
Which of the following is not a role of a stack switch?
iStackstack switch rolesMaster/Backup/Slaveswitch stacking - Question #161Layer 2 Technologies
As shown in the figure, which of the following statements is correct?
STP port rolesRSTPAlternative portBackup port - Question #162IPv4 Routing Technologies
A router LSA is shown in the figure, which of the following statements is wrong?
OSPF Router LSADR electionadjacencyexternal routes - Question #163MPLS and MPLS VPN
Check the label on a router and see the following results: Which of the following statements is correct?
MPLS label forwardinglabel stackLIBpenultimate hop popping - Question #164IPv4 Routing Technologies
As shown in the figure, the IS-IS neighbor relationship between R1 and R2 has just been established, and the database synchronization process between R1 and R2 is correct?
IS-IS database synchronizationCSNPPSNPLSP - Question #165Layer 2 Technologies
As shown in the figure, both SWA.SWB.SWC run RSTP. What is the port role of GE0/0/2 port on SWB and GE0/0/1 port on SWC?
RSTP port rolesAlternative portBackup portspanning tree election - Question #166Layer 2 Technologies
In the switching network shown in the figure, all switches run the STP protocol. When the topology is stable, modifying the sending cycle of the configuration BPDU on which of the...
STP root bridgeconfiguration BPDUBPDU timerspanning tree - Question #167IPv4 Routing Technologies
In a given network structure and OSPF partitions shown in the figure. In the figure, except RTA, RTB, RTC and RTD are all ABR routers.
OSPF ABRmulti-area OSPFarea border routerbackbone area - Question #168Layer 2 Technologies
If the data frames shown in the figure and the configuration on the interconnection port of the switch, it can be judged that the data frame tagged with VLAN10 can be forwarded nor...
VLAN trunk802.1Q taggingtrunk portframe forwarding - Question #169IPv4 Routing Technologies
R1 contains the configuration shown in the figure. isis 1 net-style wide network-entity 49.0022.ee8c.a0c2.baf2.00 Which option is correct for the following description of IS-IS pro...
IS-IS device typeLevel-1-2NET addressIS-IS configuration - Question #170Layer 2 Technologies
The following is part of the output information of the router RTD. display igmp-snooping IGMP Snooping Information for VLAN 3 IGMP Snooping is Enabled IGMP IP Version is Set to def...
IGMP snoopingquery intervalmulticast VLANmax response time - Question #171IPv4 Routing Technologies
Which of the following description about the content contained in the update message is wrong?
BGP Update messagepath attributesreachable routesunreachable routes - Question #172VRP Basics and Advanced Features
Which of the following statements about stack splitting is incorrect?
iStack splittingMAD detectionmaster switch electionstack MAC - Question #173VRP Basics and Advanced Features
Which of the following statements about stacked MAD detection is incorrect?
MAD detectioniStackproxy detectiondomain ID - Question #174IPv4 Routing Technologies
Which of the following descriptions about BGP, OSPF, IS-IS, and RIP is correct?
BGP transportOSPF protocol numberRIP UDP portIS-IS transport - Question #175IPv4 Routing Technologies
The routing attributes of the three routing entries are as shown in the figure. Assume that the next hop of the three routing entries is reachable. When these three routing entries...
BGP path selectionroute attributesbest path algorithmBGP decision - Question #176IPv4 Routing Technologies
The figure below is the BGP error output information of a router. <huawei> display bgp error Error Type: Hold Timer Error Time: 2010-03-22 12:40:39 Error Address: 10.1.1.9 BGP Name...
BGP Hold TimerBGP error diagnosisneighbor relationshipBGP troubleshooting - Question #177IPv4 Routing Technologies
As shown in the figure, OSPF is enabled on all interfaces of the router. The cost value of the link is marked in the figure. Interface 0 of R2 Loopback0 is advertised in Area 0; In...
OSPF Type 3 LSAABRinter-area routingLoopback advertisement - Question #178IPv4 Routing Technologies
As shown in the figure, it is part of the output information of the router RTD. IGMP limit: 40 except: 2000 value of query interval for IGIP (negotiated):-s value of query interval...
IGMP query intervalmulticast interfaceIGMP versionquerier - Question #179Layer 2 Technologies
As shown in the figure, three first-level switches are interconnected with one HUB. The STP function is enabled on all switches. Please refer to the figure below for the STP status...
STP with HUBdesignated portalternate portroot bridge election - Question #180Layer 2 Technologies
There is an existing switch connected to a designated port through a certain port, but this port does not forward any packets, but can monitor network changes by receiving BPDUs, s...
STP Alternate portblocked stateBPDU receptionport roles - Question #181IPv4 Routing Technologies
Which of the following description of the virtual connection in OSPF is wrong?
OSPF virtual linkbackbone areaarea border routerOSPF areas - Question #182IPv4 Routing Technologies
Regarding BFD warning message "OSPF/3/BFDFAIL(OID) [1.3.6.1.2.1.14.16.2.6]: bfd session instance=virtual interface from a muter whos eauthentication key authentication type conflic...
BFD sessionauthentication conflictOSPF BFDtroubleshooting - Question #183IPv4 Routing Technologies
If five Huawei routers establish a BFD session, the sending interval of AR1 is 50 milliseconds and the receiving interval is 80 milliseconds, the sending interval of AR2 is 60 mill...
BFD negotiationtimer intervalssend intervalreceive interval - Question #184IPv4 Routing Technologies
Which of the following descriptions of the BFD session establishment method is incorrect?
BFD sessionstatic BFDdynamic BFDlocal identifier - Question #185IPv4 Routing Technologies
Which of the following OSPF packets carries master-slave relationship information?
OSPF packetsDD packetmaster-slave electionpacket types - Question #186IPv4 Routing Technologies
In the IP system, which of the following descriptions about OSPF cost (Cost) is wrong?
OSPF costinterface costloopback interfacebandwidth reference - Question #187IPv4 Routing Technologies
Which of the following descriptions about ABR in OSPF2 is wrong?
OSPF ABRLSA typesType 3 LSALSDB - Question #188IPv4 Routing Technologies
The four routers R1, R2, R3 and R4 enable OSPF to establish neighbor relationships. The topology and related parameters are shown in the figure. R1: ROUTER-ID: 1.1.1.1, G0/0/0 ip a...
OSPF DR/BDRHello packetBDR fieldDR election - Question #189Network Security
Which of the following descriptions about URPF (Unicast Reverse Path Forwarding) is correct?
URPFstrict modeloose modeIP spoofing prevention - Question #190IPv4 Routing Technologies
Which of the description of Router ID in OSPF, which of the following is incorrect?
OSPF Router IDloopback interfacerouter-id commandID selection rules - Question #191IPv4 Routing Technologies
When running the OSPF protocol exchange DD messages, which of the following parameters will be used to elect the master-slave relationship?
OSPF DD messagemaster-slave electionRouter IDneighbor adjacency - Question #192Layer 2 Technologies
In the RSTP protocol, when the network topology changes, the mechanism to respond to the topology change is:
RSTPtopology changeMAC address tableSTP convergence - Question #193IPv4 Routing Technologies
Which description of BGP reliable routing updates is correct?
BGProuting updatesTCP transportOPEN message - Question #194IPv4 Routing Technologies
In the OSPF process, what is the role of the DETAIL -SUPPRESSED option of the AGGREGATE command?
BGP aggregationdetail-suppressedaggregate-addressroute summarization - Question #195IPv4 Routing Technologies
In the network shown in the figure, OSPF runs on four routers, and they are in the same area and the same network segment. OSPF will automatically elect a DR and a BDR, and the oth...
OSPF DR/BDRbroadcast networkDROtherelection rules - Question #196Network Management and O&M
Data center equipment can be simply divided into computing equipment, storage equipment and network equipment. Which of the following is not a network device?
data centernetwork devicescomputing equipmentDC architecture - Question #197IPv4 Routing Technologies
Whether the elected DR and BDR in a broadcast network listen to both the 224.0.0.5 address and the 224.0.0.6 address
OSPF DR/BDRmulticast addresses224.0.0.5224.0.0.6 - Question #198VRP Basics and Advanced Features
When configuring dual-link hot backup in a WLAN network, the larger the value of the configured AC priority, the higher the actual priority of the AC.
WLANAC prioritydual-link hot backupAP management - Question #199Network Management and O&M
Which of the following descriptions about the limitations of traditional traffic statistics is incorrect?
traffic statisticsflow monitoringSNMP pollingACL-based statistics - Question #200IPv4 Routing Technologies
In which part of the multicast network architecture is the IGMP protocol used?
IGMPmulticast architecturemember networkmulticast forwarding