H12-811_V1.0 Exam Questions

The output information of the sub-interface of a router aggregate port 1 is shown in the figure. Based on this information, which of the following statements are correct? ()

As shown in the figure below. Router A has passed the IP address 10.0.12.2 Telnet Router B. Which of the following operations on the current interface will cause the Telnet session...

The network shown in the figure below. The host has an ARP cache. Which of the following statements are correct? )(Multiple Choice Questions)

The output information of the routing table of a certain router is shown in the figure. Which of the following statements is correct? () (Multiple Choice Questions) R1display ip ro...

The network is shown in the figure below. The following statementcorrectIs there? () (Multiple Choice Questions)

The output information of a certain router is shown in the figure. Which of the following statements are correct? () (Multiple Choice Questions)

As shown in the figure below, assuming that the other configurations of the switch are kept in the default state, which port of the following switch will become the designated port...

The G0/0/1 interface configuration information of router A is shown in the figure. Which of the following statements are correct? () (Multiple Choice Questions)

According to the following configuration, which statement is correct? () (Multiple Choice Questions) Int g0/0/1 Int g0/0/2 Port hybrid pvid vlan 20 Port hybrid pvid vlan 10 Port hy...

Which frequencies does IEEE802.11n support? ()

Which WLAN security policies support the 0pen link authentication method? ()

Which of the following statements about RA and RS in IPv6 are correct? ()

The controller is the core component of SDN. The controller is connected to the device through the southbound interface. The following is missing from the controller southbound agr...

After the two routers are configured with 0SPF, the administrator configures the command on RT

Which of the following statements about the default route are correct? ()

The function of the 0SPF hel1o message is ()

The output information of the sub-interface of a certain router's aggregation port 1 is shown in the figure. Based on this information, which of the following statements is correct...

On Huawei ARG3 series routers, what authentication modes does AAA support? ()

The output information of a certain device is shown in the figure. Which of the following statements is correct? ( ) display interface G1gabitEthernet 0/0/0 G1 gabi tEthernet0/0/0...

Which of the following commands can be used to query the configuration information of the device's 0SPF protocol? ()*

The transmission rate of the Eth-Truk port in manual link aggregation mode is related to ().*

In order to realize the network layer function on the VLANIF interface, do you need to configure it on the VLANIF interface? ()

In the CAPWAP tunnel establishment phase, after AC. receives the Join Request message sent by the AP, AC. will check the validity of the AP. Which of the following is the authentic...

Which of the following statements about the S field in the MPLS packet header are correct? ()*

Through sR (Segment Routing), an explicit path can be easily defined. The nodes in the network only need to maintain the SegmentRouting information to cope with the real-time and r...

Which of the following statements about Iv6 address configuration are correct? ()*

Which of the following descriptions about the 0SPF area is correct ()*

The route entry 10.0.0.24/29 may be aggregated from which of the following subnet routes? ()*

Which of the following statements about single-arm routing are correct? ()*

Which of the following statements about IPv6 anycast addresses are correct? ()*

Which of the following options describes the concept of the IEV architecture correct? ()*

Regarding the control plane of the device, which of the following statements is correct? ()*

Which of the following networks belong to a local area network? ()

Which of the following features does the OSPF protocol have? ()*

Which of the following elements are included in the routing table? ()*

Which of the following fields are present in both IPv6 and IPv4 packet headers? ()*

What are the three sources for routers to obtain routing entries? ()*

Is there any correct statement about the TTL field in the IPv4 header? ()

Which of the following MAC addresses cannot be used as the MAC address of the host network card? ()*

An ACL rule is as follows: Which of the following IP addresses can be matched by permit rules? () rule5per mit ip source10.0.1.00.0.254.255*

In the network shown in the figure below, there are the following configurations in Router A. Which of the following statements is correct? ip route-statiC.10.0.2.2255.255.255.2551...

Which of the following statements about RA and RS messages in IPv6 are correct? ()*

In what ways does VRP support router configuration? ()*

If the IP address of a host in the LAN is 192.168.1.1/30, which of the following IP addresses will be processed by the host as the destination address of the IP packet? ()*

After a fault occurs in the network, the administrator finds that the configuration of a certain router has been modified through troubleshooting. What measures should the administ...

When the LCP phase of PPP is negotiated, the content of the negotiation includes ()*

Which NAT can convert multiple private network addresses into one public network address to access the public network at the same time

NAT configuration is as follows, which IP can be converted when accessing the public network (RTA) acl2000 (RTA-acl-basic-2000) rule5 permit source 192.168.1.00.0.0.255 RTA-acl-bas...

What are the ACL classifications*

The NAT configuration is as follows, which IP can be converted when accessing the public network (RTA) acl2000 (RTA-acl-basic-2000) rule5 permit source 192.168.1.00.0.0.255 RTA-acl...