Which of the following VRP commands can be used to enter area 0 view?

The correct answer is A. [Huawei-ospf-1] area 0.0.0.0. In VRP, to enter the configuration view for a specific OSPF area, the syntax [Huawei-ospf-1] area 0.0.0.0 is used. This command specifies Area 0 in the correct format (dotted decimal notation) as required by VRP, which supports OSPF multi-area configuration by designating…

IP Routing Technologies

Question

Options

A[Huawei-ospf-1] area 0.0.0.0
B[Huawei-ospf-1] area 0 enable
C[Huawei-ospf-1] area 0
D[Huawei] ospf area 0

How the community answered

(60 responses)

A
78% (47)
B
8% (5)
C
10% (6)
D
3% (2)

Explanation

In VRP, to enter the configuration view for a specific OSPF area, the syntax [Huawei-ospf-1] area 0.0.0.0 is used. This command specifies Area 0 in the correct format (dotted decimal notation) as required by VRP, which supports OSPF multi-area configuration by designating specific area

Topics

#OSPF area configuration#VRP CLI syntax#area 0#OSPF process

Community Discussion

No community discussion yet for this question.

Full H12-811_V1.0 Practice