Huawei
H12-323_V2.0 · Question #212
A customer's existing network has been fully deployed with Huawei Wi-Fi 6 APs. When the engineer accepted the wireless network, he used a Wi-Fi 6 terminal to associate the wireless signal to enter…
The correct answer is A. The terminal is too far from the AP and the signal strength is low. B. Configure rate limit for a single user on the wireless controller C. The air interface environment is too noisy D. The network cable connected to the AP is a 100M network cable. See the full explanation below for the reasoning.
WLAN Troubleshooting and Optimization
Question
A customer's existing network has been fully deployed with Huawei Wi-Fi 6 APs. When the engineer accepted the wireless network, he used a Wi-Fi 6 terminal to associate the wireless signal to enter the site for speed measurement and found that the speed was only about 100Mbps. Which of the following reasons may cause this result? (Multiple choice)
Options
- AThe terminal is too far from the AP and the signal strength is low.
- BConfigure rate limit for a single user on the wireless controller
- CThe air interface environment is too noisy
- DThe network cable connected to the AP is a 100M network cable
How the community answered
(54 responses)- A100% (54)
Topics
#Wi-Fi 6#speed troubleshooting#rate limiting#interference
Community Discussion
No community discussion yet for this question.