Which of the following commands can view the current configuration of AC?

Question

Options

• Adisplay interface
• Bdisplay current-configuration
• Cdisplay ap all
• Ddisplay version

• A
  3% (1)
• B
  84% (27)
• C
  3% (1)
• D
  9% (3)

Explanation

display current-configuration is the correct command because it outputs the complete running configuration of an Access Controller (or any Huawei network device), showing all active settings including WLAN profiles, interfaces, and policies - exactly what you need to audit or verify the device's current state.

Why the distractors are wrong:

• A. display interface - shows interface status and statistics (up/down, packet counts, errors), not the full device configuration.
• C. display ap all - lists associated Access Points and their connection status; it's AP inventory, not device configuration.
• D. display version - shows hardware model, software version, and uptime, which is system info, not configuration.

Memory tip: Think "current" = configuration as it exists right now. On Huawei VRP-based devices, display current-configuration is the go-to command analogous to Cisco's show running-config - if you know one, map it to the other.

No community discussion yet for this question.