H12-224 Exam Questions
401 real H12-224 exam questions with expert-verified answers and explanations. Page 7 of 9.
- Question #429
Which of the following statements about link aggregation are true? (Select 3 Answers)
- Question #430
When links are switched in a Smart Link group, which of the following mechanisms can be used to refresh MAC and ARP entries? (Select 3 Answers)
- Question #432
Routes 172.1.12.0/24, 172.1.13.0/24, 172.1.14.0/24, and 172.1.15.0/24 can be summarized into route 172.1.8.0/21.
- Question #433
Which of the following statements are true? (Select 3 Answers)
- Question #434
A router receives a data packet, with the destination address being 195.26.17.4. Which subnet is this address in?
- Question #435
Which of the following statements about the reliability requirement level are true? (Select 3 Answers)
- Question #436
The value of ospfdr-priority ranges from 0 to 255 and the default value is 64.
- Question #437
Which of the following route selection mechanisms can adopt user-defined policies to determine data forwarding paths flexibly based on ACLs or packet lengths?
- Question #438
Which of the following statements about Stub areas is false?
- Question #439
If the network address 172.29.100.0/16 is subnetted, which of the following valid VLSM subnets can be obtained?
- Question #440
Which of the followings are OSPF packet type? (Select 3 Answers)
- Question #441
The IP address 0.0.0.0 indicates ().
- Question #442
What is the link ID of an ASBR-Summary-LSA?
- Question #443
When the GR Restarter performs the active/standby switchover, the neighbor performs which of the following operations when detecting that a TCP disconnection? (Select 3 Answers)
- Question #444
On a broadcast network or an NBMA network, not all neighbors need to set up adjacencies. Therefore, the concept about the adjacency is applicable to only the broadcast network or t...
- Question #445
Which is the default network mask length of 219.25.23.56?
- Question #446
MPLS is a switching standard defined by the IETF. Which of the following devices exist on the MPLS network? (Select 2 answers)
- Question #447
The vlink-peer command is used to specify a peer IP address for setting up a virtual link.
- Question #449
Which of the following statements about BFD are true? (Select 3 Answers)
- Question #450
Which statements regarding the PVID on the access interface are true? (Select 3 answers)
- Question #451
An OSPF neighbor relationship fails to be established and the display ospf error command output is as follows. Which of the following is the probable cause?
- Question #452
A network administrator needs to construct a small-scale network containing only 22 hosts and the ISP assigns only one public IP address as the egress address. Which of the followi...
- Question #453
Which of the following statements about state transition are true? (Select 3 Answers)
- Question #454
On a non-broadcast network, OSPF has two operating modes: NBMA and P2MP.
- Question #455
The most remarkable characteristic of OSPF is that OSPF supports the link-state algorithm.
- Question #456
The route selection tool route-policy can filter and set BGP attributes based on pre-defined conditions. Therefore, this tool is commonly used to define policies for BGP peers and...
- Question #457
What is the maximum bits of a Class C address can be used for subnet?
- Question #458
Which of the following statements about the setup of a BFD session are true? (Select 3 Answers)
- Question #459
Which of the following statements about the Smart Link group is false?
- Question #460
Different from a Stub area, an NSSA supports Type-5 LSAs.
- Question #461
Which of the following are characteristics of a high availability network?(Select 2 Answers)
- Question #462
Which of the following statements about NSSA commands is false?
- Question #463
Which of the following Statement is false?
- Question #464
One class B network 155.16.0.0, the mask is 255.255.255.192. then subnet quantity available is ( ) , the host quantity in every subnet at most is ()
- Question #465
The NBMA mode requires all the routers in the network to be fully connected; otherwise, it does not function.
- Question #466
In IPv4, which of the following is the SSM address range allocated by the IANA?
- Question #467
Which of the following statements about VLSM characteristics are true?(Select 2 Answers)
- Question #468
Which of the following statements about the BFD demand mode are true?(Select 2 Answers)
- Question #469
Different types of networks cannot establish an adjacency in the Full state.
- Question #470
A Class C network needs to be divided into five subnets and each subnet needs to contain a maximum of 20 hosts. Which of the following subnet masks is used?
- Question #471
How many Class C networks does the summarized route 192.168.134.0/22 cover?
- Question #472
When two routers exchange LSDB information by exchanging DD packets, a master/slave relationship is established between the two routers. The router with a larger router ID is the m...
- Question #473
The subnet mask of a class A address is 255.255.240.0, how many bits are used to divide subnet?
- Question #474
In VRP 5.7, which of the following dynamic protocols support GR? (Select 3 Answers)
- Question #475
Which of the following address types are reserved for multicast use?
- Question #476
Which of the following statements regarding IP address 224.0.0.1 are correct?(Select 2 Answers)
- Question #477
By default, the cost of an OSPF interface is related to interface bandwidth. The algorithm for calculating the cost is: bandwidth-reference/bandwidth.
- Question #478
Which statements about OSPF packets are true? (Select 3 Answers)
- Question #479
How many hosts are available per subnet if apply a /21 mask to the class B network?
- Question #480
OSPF supports the combination of a group of network segments. Such a group is also called an area. In other words, an area is a set of network segments.