H12-224 Exam Questions
401 real H12-224 exam questions with expert-verified answers and explanations. Page 1 of 9.
- Question #1
Which types of interfaces are supported by Huawei switches after the VLAN function is configured? (Select 3 Answers)
- Question #2
The option field in a DHCP message uses the CLV mode.
- Question #3
Which of the following statements about a multicast distribution tree are true? (Select 3 Answers)
- Question #4
Which of the following routes matches this ACL filter? "acl number 2001 rule 0 permit source 1.1.0.0 0"
- Question #5
What does the IP-prefix-filter "ipip-prefix test index 10 deny 0.0.0.0 0 less-equal 32" mean?
- Question #6
Which of the following statements is true regarding the function of VRRP?
- Question #7
Default routes between routers are a low-cost solution. This is because using default routes requires less system resources than maintaining a complete routing table.
- Question #8
How many bits of the MAC address space is available for mapping IP multicast addresses?
- Question #9
Which of the following commands is used to display the IGMP routing table?
- Question #10
For link-status routing protocols, filtering routes in the inbound direction actually cannot block the transmission of link-status information. The filtering effect is that routes...
- Question #11
Which of the following is not supported by policy-based route for specifying the data forwarding path?
- Question #12
Which of the following problems can be solved by IGMP Snooping?
- Question #13
What are the advantages of subnetting? (Select 2 answers)
- Question #14
Which type of BGP route can be added to the BGP routing table?
- Question #15
On a STP network, which of the following BPDUs are sent during flooding of information throughout the network due to STP topology change?
- Question #16
Which of the following multicast protocols can generate multicast distribution trees?
- Question #17
When an edge port is in the protected state on an RSTP network, which of the following operations is performed by the edge port immediately after receiving BPDUs?
- Question #18
Which of the following statements about DR are true? (Select 3 Answers)
- Question #19
How many multicast IP addresses can be represented by an IP multicast MAC address?
- Question #20
A VLAN can be regarded as a ( )
- Question #21
For label switched packets that contain the same source and destination address and are transmitted via the same interface, the label switch path 0
- Question #22
One route-policy may have several nodes and each node has a node ID. Each node may have "multiple" if-match and apply clauses. Which of the following statements are true?(Select 2...
- Question #23
The unicast and multicast technologies are both outstanding in solving the problem of one source and "multiple" destinations for efficient P2MP data transmission.
- Question #24
Which of the following is the address range assigned byIANA for SSM service in IPv4?
- Question #25
Which of the following route prefixes match this IP-prefix-filter? (Select 3 Answers) "ipip-prefix test index 10 permit 10.0.0.0 16 greater-equal 24 less-equal 28"
- Question #26
Which of the following commands is used to display check information of IGMP enabled interface?
- Question #27
Which of the following statements are true regarding VRRP?
- Question #28
An OSPF neighbor relationship fails to establish and the OSPF error information is displayed as follows. Which of the following is most likely the cause?
- Question #29
Which of the following messages exist only in PIM-SM?(Select 2 Answers)
- Question #30
Which of the following statements regarding Router-LSA connection type (Type) is false?
- Question #31
Which of the following statements regarding Network-Summary-LSA are true? (Choose all that apply.)
- Question #32
Which of the following statements regarding the OSPF shortest path tree computation phase is true?
- Question #33
Which of the following statements regarding the OSPF protocol are true? (Choose all that apply.)
- Question #34
Which of the following statements regarding OSPF multi-instance is false?
- Question #35
Which of the following statements regarding OSPF packets is false?
- Question #36
OSPF supports multiple network types. Which of the following network types require DR and BDR to be elected? (Choose all that apply.)
- Question #37
Compared with OSPF, which of the following statements regarding IS-IS are true? (Choose all that apply.)
- Question #38
Which of the following commands can enable IS-IS on an interface?
- Question #39
Which of the following procedures are included in IS-IS route calculation? (Choose all that apply.)
- Question #40
Which of the following statements regarding BGP is false?
- Question #41
Which of the following BGP attributes are well-known community attributes? (Choose all that apply.)
- Question #42
BGP is an enhanced distance-vector routing protocol. Which is the major reason for this?
- Question #43
Once a BGP connection is established, if load balancing is not configured, a BGP Speaker just advertises the optimal route in its BGP routing table to its neighbors.
- Question #44
Which of the following configuration can enable indirectly connected EBGP peers to establish a connection normally?
- Question #45
When the Hold Time parameter negotiated between two BGP peers is 0, no Keepalive messages will be sent.
- Question #46
Which of the following statements regarding BGP message types and characteristics is false?
- Question #47
The first four bits of a multicast IP address are fixed as 1110 and are mapped to the most significant 25 bits of a multicast MAC address. Among the last 28 bits of a multicast IP...
- Question #48
IGMP Snooping runs on the data link layer to manage and control multicast groups and prevents multicast packets on Layer 3 broadcasts.
- Question #49
Which of the following route selection tools can be used by other routing protocols in addition to BGP? (Choose all that apply.)
- Question #50
Which of the following statements regarding routing policy and policy-based routing are true? (Choose all that apply.)