H12-211_V3.0 Exam Questions
1,013 real H12-211_V3.0 exam questions with expert-verified answers and explanations. Page 14 of 21.
- Question #658
Which fields are not included in the network layer header format?
- Question #659
Which of the following descriptions are correct if an AR2200 router needs to be restored to its initial configuration? (Multiple Choice)
- Question #660
The administrator wants to completely delete the old device configuration file <config.zip>, then which of the following command is correct?
- Question #661
In which of the following cases does the switch generate configuration BPDUs? (Multiple Choice)
- Question #662
The port cost calculated by STP has a certain relationship with the port bandwidth, that is, the larger the bandwidth, the () the overhead.
- Question #663
In the RSTP protocol, the P/A mechanism requires that the link between two switching devices be in point-to-point full-duplex mode.
- Question #664
The output information of a router is as follows. Which of the following statements are correct? (Multiple Choice)
- Question #665
Which of the following commands can enable the DHCP relay function of the router interface?
- Question #666
As shown in the following figure, Switch A and Router A are connected through two links. The two links are in the manual load balancing mode. The aggregation port number is 1, and...
- Question #667
As shown in the figure, the network administrator creates VLAN 2 on the SWA and SWB, and configures the ports connected to the hosts on the two switches as access ports and assigns...
- Question #668
If the Authenticator sends the wrong username and password to the Authenticator during the PPP authentication process, what type of message will the Authenticator send to the Authe...
- Question #669
An ACL is a packet filter. The ACL is applied to the service module. The ACL takes effect.
- Question #670
An ACL rule is as follows: rule 5 permit ip source 10.0.1.0 0.0.254.255 Which of the following IP addresses can be matched by the permit rule? (Multiple Choice)
- Question #671
When an IPv6 interface receives a packet whose Hop Limit class has a value of 1, the packet is not forwarded.
- Question #672
By default, how many seconds is the OSPFv3 adjacency Deadtime on a P2P link?
- Question #673
An explicit path can be easily defined by SR (Segment Routing), and nodes in the network only need to maintain Seament Routing information. It can respond to the real-time rapid de...
- Question #674
Which of the following statement about MPLS Label tags is wrong?
- Question #675
Which statement is correct about the VRP operating platform shortcuts? (Multiple Choice)
- Question #676
Which statement is wrong about the above configuration command? <Huawei>system-view [Huawei]user-interface console 0 [Huawei-ui-console0] user privilege level 15 [Huawei-ui-console...
- Question #677
In the switch, which of the following is the technology of port and MAC binding?
- Question #678
Which of the following information does the switch MAC address table not include?
- Question #679
What port states might exist on a switch with standard STP protocol enabled? (Multiple Choice)
- Question #680
Which of the following routing protocols has the highest priority?
- Question #681
Referring to the output result shown in the figure, it can be judged that the routing table of the router is composed of a direct route and a static route.
- Question #682
Which of the following description is correct about the display information?
- Question #683
The output information of a link aggregation port of a switch is as follows. If you want to delete Eth-Trunk 1, which of the following command is correct?
- Question #684
If an Ethernet data frame Length/Tyme=0z8100, which may be the payload of this data frame? (Multiple Choice)
- Question #685
As shown in the figure, a static NAT command is deployed on the router R1. When the PC accesses the Internet, the destination address in the packet will not change.
- Question #686
What level of encapsulation format is defined by the PPP protocol in the OSI reference model?
- Question #687
Which of the following authentication methods does not require to input a username and password?
- Question #688
When forwarding a IPv6 packet, the router needs to find the routing table based on the source IP address of the IP6 packet.
- Question #689
Which order is the OSI reference model from the upper layer to the lower layer?
- Question #690
Network administrators use Ping to test network connectivity. Which of the following protocols might be used in the process? (Multiple Choice)
- Question #691
As shown in the figure, it can be judged that 00e0-fc99-999 is a specific host MAC address learned by the switch through ARP, and the host has changed the IP address three times.
- Question #692
Which statement is correct about the above configuration command? <Huawei>system-view [Huawei]command-privilege level 3 view user save
- Question #693
Which of the following OSPF protocol packets can ensure the reliability of the LSA update?
- Question #694
Which of the following protocols does not belong to the file transfer protocol?
- Question #695
Apply the following ACL to Telnet: Acl number 2000 Rule 5 permit source 172.16.105.20 # Only devices with an IP address of 172.16.105.2 are allowed to log in remotely.
- Question #696
Using the ACL matching route entry shown above on the router RTA, which of the following entries will be matched? (Multiple Choice) [RTA] ac12002 [RTA-acl-basic-2002] rule deny sou...
- Question #697
Which type of ACL does the following command belong to? rule permit 8021p 7
- Question #698
How many bits does the total length of an IPv6 address increase over IPv4?
- Question #699
What kind of IPv6 address is FE80::2EO:FCFF:FE6F:4F36?
- Question #700
If the IPv6 host wants to send packets up to 10 routers, which parameter should be modified in the IPv6 header?
- Question #701
There are two routers RTA and RTB between the source device and the destination device. Use the Tracert command to detect the path. When the first hop RTA is detected, the source d...
- Question #702
This is the three packets that the administrator has captured on the network. Which of the following statements is incorrect?
- Question #703
The administrator needs to configure the IP address on the G0/0/0 interface of the router. Which of the following address is correct to use?
- Question #704
The subnet mask of a network segment 150.25.0.0 is 255.255.224.0, then which is the valid host address in the network segment? (Multiple Choice)
- Question #705
How many port states does the RICMP protocol have?
- Question #706
A router running OSPF can reach the FULL state after completing the LSDB synchronization.
- Question #707
Which of the following is not included in the routing table?