Huawei
H12-211_V3.0 · Question #946
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not as expected and performs debugging. Based on the output from the debug, what is the…
The correct answer is D. R2 is operating using RIPv2, while R1 is using RIPv1. See the full explanation below for the reasoning.
Question
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not as expected and performs debugging. Based on the output from the debug, what is the source of the problem?
Options
- AR2 has configured an ACL to block the route to network 1.0.0.0
- BR2 has enabled split horizon.
- CR1 is using authentication, however R2 is not.
- DR2 is operating using RIPv2, while R1 is using RIPv1.
How the community answered
(37 responses)- A8% (3)
- B3% (1)
- C14% (5)
- D76% (28)
Community Discussion
No community discussion yet for this question.