GB0-180 Exam Questions

To view the encapsulation type of the Frame Relay network on Quidway routers, which of the following commands should be used( )

Which of the following option best describes the access control list:( )

To validate the access control list, the requisite steps are:

In the access control list, the operator "greater-port portnumber" indicates control over( )

The default application direction "ip access-group" command at the interface is:

To save the current configuration information of Quidway router in the flash, which command should be input?

In which of the following manners can Quidway router be configured?

Which of the following interfaces can serve as standby interface?

The purpose of standby center is for( )

Which of the following statements concerning the private IP address that IANA reserves is NOT true?

Which of the following device belongs to physical layer( )

Which of the following is the function of data link layer of OSI reference model?

Modem is a kind of equipment of Lan.

WAN usually adopt circuit switching or packet switching technology.

The network part of the IP address, 190.233.27.13/16, is ( )

Frame relay protocol works in which layers of ISO/OSI reference model?

Which of the following belong to Wan protocols?

For network segments:172.168.16.0,172.168.17.0, 172.168.18.0, 172.168.19.0, which of the following network segments is the best to implement route aggregation?

Which of the following addresses is in the same network segment with 10.110.53.233:

The network address of the IP address 125.3.54.56 without any subnet is( )

Which of the following statements concerning Ethernet switch are true:

During the process of forwarding packets to indirect connected network segment, upon which does Quidway router find the next hop address?

The principle used to evaluate the routing algorithm does NOT include( )

Which of the following command is correct, to configure user list on Quidway router?

10M Ethernet has three types of interface standard, where 10BASE-T adopts

In the broadcast packet sent by one windows mechanism when it starts, the destination MAC address is( )

The shared Ethernet adopts ( ) protocol to support bus type architecture

In the Ethernet switch, which of the following forwarding method with lower delay( )

Which of the following are included in PPP protocol family ?

Which of the following are point-to-point link layer protocols:

When V.24 cable is working in asynchronous mode, which of the following link layer encapsulation protocols can be adopted?

For RIP protocol, the maximum hop count of destination network (the count of routers it passes by):

( ) route protocols have routing loop problem.

Which of the following routing table options need to be configured manually by the network administrator( )

When the interface runs in RIP-2 broadcast mode, it is able to receive the packets including:

ARP is an address resolution protocol that uses broadcast, and it also uses ARP cache, for the use of broadcast will waste a large amount of bandwidth

Tracert is a kind of route tracing tool used to monitor the connectivity of the network layer

IGMP protocol is implemented on which layer of TCP/IP protocol?

As the network layer equipment, the router has two main characteristics as below:

Please click the exhibit button. Suppose there is a networking case like this: Two Quidway router(RTA and RTB) are connected through the serial port. The IP address of the serial p...

Please click the exhibit button. E0 and E1 of a Quidway router are connected to two network sections. E0 (its IP address is 10.1.1.1 and its subnet mask is 255.255.255.0) is connec...

The routing table of one router is as below: Route Tables: Destination/Mask Proto Pref MetricNexthopInterface 2.0.0.0/8 Direct 0 0 2.2.2.1 Serial0 2.2.2.1/32 Direct 0 0 2.2.2.1 Ser...

Inverse ARP functions mainly to:

As a widely-used WAN technique, Frame Relay has many outstanding characteristics, which does NOT include( )

Dialer port is a logical port. One Dialer port can contain multiple physical ports. The relationship between Dialer port and physical port is( )

Which of the following is narrowband public network

Concerning Gigabits Ethernet, which of the following is true( )

By using CIDR technology ,which of the following options are correct on route aggregation?( )

The subnet is divided at the ( ) part of IP address

For a traditional Class C network without subnet division, how many hosts are allowed to be installed at most?