FCSS_EFW_AD-7.4 · Question #45
Refer to the exhibit, which shows an enterprise network connected to an internet service provider. The administrator must configure the BGP section of FortiGate A to give internet access to the…
The correct answer is A. config neighbor. In BGP (Border Gateway Protocol), a neighbor (peer) configuration is required to establish a connection between two BGP routers. Since FortiGate A is connecting to the ISP (Autonomous System 10) from AS 30, the administrator must define the ISP's BGP router as a neighbor. The…
Question
Refer to the exhibit, which shows an enterprise network connected to an internet service provider. The administrator must configure the BGP section of FortiGate A to give internet access to the enterprise network. Which command must the administrator use to establish a connection with the internet service provider?
Exhibit
Options
- Aconfig neighbor
- Bconfig redistribute bgp
- Cconfig router route-map
- Dconfig redistribute ospf
How the community answered
(34 responses)- A82% (28)
- B6% (2)
- C9% (3)
- D3% (1)
Explanation
In BGP (Border Gateway Protocol), a neighbor (peer) configuration is required to establish a connection between two BGP routers. Since FortiGate A is connecting to the ISP (Autonomous System 10) from AS 30, the administrator must define the ISP's BGP router as a neighbor. The config neighbor command is used to: Define the ISP's IP address as a BGP peer Specify the remote AS (AS 10 in this case) Allow BGP route exchanges between FortiGate A and the ISP
Topics
Community Discussion
No community discussion yet for this question.