Dell-EMC
E20-690 · Question #225
After a new VNX 5400 was installed and powered up, the Data Movers are continuously rebooting. It has been determined that a cabling issue is at fault. Which configuration should be checked first as…
The correct answer is A. Data Mover to SP FC cabling. See the full explanation below for the reasoning.
Question
After a new VNX 5400 was installed and powered up, the Data Movers are continuously rebooting. It has been determined that a cabling issue is at fault. Which configuration should be checked first as the most likely cause?
Options
- AData Mover to SP FC cabling
- BSPS to vault DAE cabling
- CBlade Enclosure network cabling
- DDAE SAS cabling
How the community answered
(69 responses)- A81% (56)
- B3% (2)
- C6% (4)
- D10% (7)
Community Discussion
No community discussion yet for this question.