Dell-EMC
E20-690 · Question #188
You are onsite to replace a faulted Data Mover. After the faulted Data Mover has been physically replaced, which command will return the primary Data Mover back to an active state?
The correct answer is A. server_standby < movername> -restore mover. See the full explanation below for the reasoning.
Question
You are onsite to replace a faulted Data Mover. After the faulted Data Mover has been physically replaced, which command will return the primary Data Mover back to an active state?
Options
- Aserver_standby < movername> -restore mover
- Bserver_standby < movername> - activate mover
- Cserver_setup < movername> -load mover
- Dserver_setup < movername> -start mover
How the community answered
(51 responses)- A71% (36)
- B6% (3)
- C20% (10)
- D4% (2)
Community Discussion
No community discussion yet for this question.