Dell-EMC
E20-597 · Question #68
A customer is adding new tape devices to an EMC NetWorker server. The command is issued to scan for devices but does not find the new devices. What is the most likely cause?
The correct answer is A. Devices have not been zoned to the server. See the full explanation below for the reasoning.
Question
A customer is adding new tape devices to an EMC NetWorker server. The command is issued to scan for devices but does not find the new devices. What is the most likely cause?
Options
- ADevices have not been zoned to the server
- BDevices are not initialized until jbconfig has been initiated.
- CLocal device bootstrap has not been configured on the hard drive.
- DPAX translation mini-driver has not been installed.
How the community answered
(20 responses)- A85% (17)
- B10% (2)
- C5% (1)
Community Discussion
No community discussion yet for this question.