A system administrator has configured a Unity storage system using the Initial Configuration wizard. After completing the wizard, the administrator discovers that an incorrect IP address has been…

The correct answer is D. The IP address can only be changed using the UEMCLI. The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP address when the Connection Utility (CU) is not available on the network. If an address is set, this command can also change the management IPv4 and IPv6 configuration…

Install and Configure Dell EMC Unity Systems

Question

A system administrator has configured a Unity storage system using the Initial Configuration wizard. After completing the wizard, the administrator discovers that an incorrect IP address has been assigned to the Unity system. How can the IP address be changed?

Options

AThe IP address cannot be changed once it has been configured
BThrough the Service interface using the if config command
CIn the Unisphere Settings menu
DThe IP address can only be changed using the UEMCLI

How the community answered

(45 responses)

A
4% (2)
B
16% (7)
C
7% (3)
D
73% (33)

Explanation

The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP address when the Connection Utility (CU) is not available on the network. If an address is set, this command can also change the management IPv4 and IPv6 configuration mode. It attempts to configure the system with the given friendly name and/or network Note: The Unisphere CLI (UEMCLI) is a tool that provides us with the CLI access to perform the same actions as one would on the Unisphere web interface.

Topics

#IP address#UEMCLI#Initial Configuration wizard#network settings

Community Discussion

No community discussion yet for this question.

Full E20-393 Practice