Dell-EMC
E20-390 · Question #380
You have installed and implemented a VNX for File. After manual failover tests have been performed, a problem occurs on the primary Data Mover and the system becomes unavailable to the users. While…
The correct answer is A. Failover policy is set to manual. See the full explanation below for the reasoning.
Question
You have installed and implemented a VNX for File. After manual failover tests have been performed, a problem occurs on the primary Data Mover and the system becomes unavailable to the users. While reviewing the status in Unisphere, the Data Mover is reported as fault/panic and no failover occurs. What is the reason for this issue?
Options
- AFailover policy is set to manual
- BHardware configuration mismatch between the primary and standby Data Movers
- CPrimary Data Mover configuration is not visible to the standby Data Mover
- DFailover will not occur when the Data Mover is in a panic state
How the community answered
(69 responses)- A81% (56)
- B6% (4)
- C3% (2)
- D10% (7)
Community Discussion
No community discussion yet for this question.