Dell-EMC
E20-385 · Question #73
An EMC Data Domain customer wants to set up link aggregation using two network interface connections. The connections will go from the Data Domain system to Switch A and Switch B. The following IP/…
The correct answer is A. Bonding mode is unsupported. See the full explanation below for the reasoning.
Question
An EMC Data Domain customer wants to set up link aggregation using two network interface connections. The connections will go from the Data Domain system to Switch A and Switch B. The following IP/ networking configuration will be used to create the aggregation:
Switch A is connected to DD interface eth3a 10 GB link IP = 10.200.1.10 Switch B is connected to DD interface eth4b 1 GB link IP = 10.200.1.11 Which mode would you recommend for this configuration?
Options
- ABonding mode is unsupported
- BRound Robin
- CLACP
- DBalanced
How the community answered
(22 responses)- A77% (17)
- B5% (1)
- C14% (3)
- D5% (1)
Community Discussion
No community discussion yet for this question.