Dell-EMC
E20-324 · Question #222
A customer wants your assistance in deciding if their existing VNX array can be used to do backup-to-disk instead of for tape backups. The customer has a VNX Unified storage system that is fully…
The correct answer is C. Array can be used, but an additional SP must be added to the array. See the full explanation below for the reasoning.
Question
A customer wants your assistance in deciding if their existing VNX array can be used to do backup-to-disk instead of for tape backups. The customer has a VNX Unified storage system that is fully populated with 125 disks. When looking at analyzer data for the array, you see that it has a consistent utilization of over 70% on both SPs. According to EMC best practices, what should be recommended to the customer?
Options
- AArray should not take on the additional load
- BVNX is not supported as a backup-to-disk target
- CArray can be used, but an additional SP must be added to the array
- DArray can be used, but an additional blade is needed
How the community answered
(45 responses)- A9% (4)
- B18% (8)
- C71% (32)
- D2% (1)
Community Discussion
No community discussion yet for this question.