Dell-EMC
DES-1721 · Question #78
After an initial implementation of a SC Fibre Channel front-end, during the failover test one of the controllers gets reset. All Virtual WWNs from the reset controller are migrated to a single port…
The correct answer is A. Check cabling, FC Zoning or Fault Domains for incorrect configuration and revise as needed. See the full explanation below for the reasoning.
Question
After an initial implementation of a SC Fibre Channel front-end, during the failover test one of the controllers gets reset. All Virtual WWNs from the reset controller are migrated to a single port of the remaining controller. What corrective action should be taken?
Options
- ACheck cabling, FC Zoning or Fault Domains for incorrect configuration and revise as needed
- BIncorrect cables used, re-cable as needed
- CThis is the expected behavior and the test completed successfully
- DFC zoning is not enabled, enable zone config
How the community answered
(64 responses)- A83% (53)
- B9% (6)
- C5% (3)
- D3% (2)
Community Discussion
No community discussion yet for this question.