Dell-EMC
D-PSC-DS-23 · Question #79
Refer to the exhibit. You want to add redundancy to your network configuration, rather than performance. You have configured all interfaces into the default SmartConnect zone. How should you…
The correct answer is D. Configure the switch ports as access points, bond ext-0 and ext-1 on all nodes and use. See the full explanation below for the reasoning.
Question
Refer to the exhibit. You want to add redundancy to your network configuration, rather than performance. You have configured all interfaces into the default SmartConnect zone. How should you configure the switches and Isilon networking to provide your desired network redundancy?
Exhibit
Options
- AConfigure the switch ports for LACP and use LACP aggregation for subnet0:pool0.
- BConfigure the switch ports as access points and use LACP aggregation for subnet0:pool0.
- CConfigure the switch ports for LACP and use FEC aggregation for subnet0:pool0.
- DConfigure the switch ports as access points, bond ext-0 and ext-1 on all nodes and use
How the community answered
(48 responses)- A13% (6)
- B6% (3)
- C2% (1)
- D79% (38)
Community Discussion
No community discussion yet for this question.