Dell-EMC
D-NWG-FN-23 · Question #252
A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a…
The correct answer is B. The new switch's interface is in the wrong subnet to form a RIP relationship. See the full explanation below for the reasoning.
Question
A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a possible cause of this issue?
Options
- AThe existing switch has not been configured with the command "hostroutesaccept".
- BThe new switch's interface is in the wrong subnet to form a RIP relationship.
- CThe "ip helper-address" command has not been configured on the existing switch.
- DThe other switch is not a root bridge and cannot form an RIP relationship.
How the community answered
(48 responses)- A2% (1)
- B77% (37)
- C13% (6)
- D8% (4)
Community Discussion
No community discussion yet for this question.