Dell-EMC
D-NWG-FN-23 · Question #238
Which commands are required to properly configure an OS10 switch to run OSPF on eth1/1/3 and to add network 144.254.1.0/30 to OSPF area 0?
The correct answer is C. OS10(config)# interface ethernet 1/1/3. See the full explanation below for the reasoning.
Question
Which commands are required to properly configure an OS10 switch to run OSPF on eth1/1/3 and to add network 144.254.1.0/30 to OSPF area 0?
Options
- AOS10(config)# interface ethernet 1/1/3
- BOS10(config)# router ospf 1
- COS10(config)# interface ethernet 1/1/3
- DOS10(config)# interface ethernet 1/1/3
How the community answered
(65 responses)- A8% (5)
- B5% (3)
- C71% (46)
- D17% (11)
Community Discussion
No community discussion yet for this question.