D-NWG-FN-23 · Question #108
Refer to the output: console#show interfaces switchport gigabitethernet 1/0/5 Port: Gi1/0/5 VLAN Membership Mode: Access Mode Access Mode VLAN: 3 General Mode PVID: 1 (default) General Mode Ingress…
The correct answer is D. The port is currently configured for a single VLAN. See the full explanation below for the reasoning.
Question
Refer to the output:
console#show interfaces switchport gigabitethernet 1/0/5 Port: Gi1/0/5 VLAN Membership Mode: Access Mode Access Mode VLAN: 3 General Mode PVID: 1 (default) General Mode Ingress Filtering: Enabled General Mode Acceptable Frame Type: Admit All General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1 General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default) Trunking Mode Native VLAN Tagging:
Disabled Trunking Mode VLANs Enabled: All Private VLAN Host Association: none Private VLAN Mapping:
Private VLAN Operational Bindings:
Default Priority: 0 Protected: Disabled Port Gi1/0/5 on a Dell N2024 will be used to create an IEEE 802.1Q-compliant trunk to another switch. Why will the trunk fail to form?
Options
- AThe correct IP address has not been configured.
- BNative VLAN tagging is disabled.
- CVLANs have not been created on this switch.
- DThe port is currently configured for a single VLAN.
How the community answered
(16 responses)- A6% (1)
- B13% (2)
- C6% (1)
- D75% (12)
Community Discussion
No community discussion yet for this question.