CWS-100 Exam Questions
59 real CWS-100 exam questions with expert-verified answers and explanations. Page 1 of 2.
- Question #1
If created correctly, what document would define the available infrastructure services on an existing wired network?
- Question #2
What 802.11 fast roaming solution allows a client to authenticate to a different AP than that to which it is connected through the AP to which it is connected?
- Question #3
An organization wishes to ensure that a fairly even distribution of clients is spread across the installed APs. What common vendor feature should be implemented to allow for this?
- Question #4
For what is the S1G (Sub-1 GHz) PHY (Physical Layer) most likely to be used?
- Question #5
Why must a cloud-managed AP have access to the Internet for initial setup?
- Question #6
Using Dynamic Rate Switching (DRS), when a client must change to a lower data rate, what best defines the action?
- Question #7
Where is an omnidirectional antenna typically placed for best results?
- Question #8
What statement best defines a staggered channel plan or multiple channel architecture (MCA)?
- Question #9
What should be used to manage an AP that requires direct web-based configuration?
- Question #10
Which one of the following is an example of a real-time communications application?
- Question #11
What is the maximum data rate specified in the 802.11 standard for the HT (802.11n) PHY (Physical Layer)?
- Question #12
An AP has two Ethernet wired networking ports. One (port 1) is labeled with a Power over Ethernet (PoE) indicator and the other (port 2) is not. What is unique about port 1 when co...
- Question #13
What is the name given to the WPA2 implementation that uses a PSK (Pre-Shared Key)?
- Question #14
What is implemented in 802.11 networks to increase the probability that higher priority communications will occur before lower priority communications?
- Question #15
Which one of the following is an example of an antenna used mostly for bridge links?
- Question #16
Which one of the following is a most likely a signal strength minimum requirement for Voice over IP (VoIP) 802.11 handsets?
- Question #17
When a WLAN must support only authorized users and no client device constraints exist, what security solution should be used?
- Question #18
What is required for some 5 GHz channels that may prevent their consistent use near an airport?
- Question #19
What 802.11 PHY (Physical Layer) operates in 60 GHz?
- Question #20
What common vendor feature can be enabled to encourage client devices to use a 5 GHz connection instead of a 2.4 GHz connection?
- Question #21
As RF waves pass through materials, what usually occurs?
- Question #22
What kind of security constraint can always be legally enforced on an organization?
- Question #23
A tablet is a single stream client with one radio and one antenna. What 802.11 features is definitely not supported on this device?
- Question #24
In what frequency band does an 802.11g (ERP) device operate?
- Question #25
What user behavior is most likely to require Wi-Fi coverage between buildings on the same campus?
- Question #26
In what kind of BSS is a gate and portal used based on the 802.11 standard?
- Question #27
You have a switch supporting 802.3at and you must power an AP that is 40 meters from the switch. What can be used to provide power to the AP?
- Question #28
Which one of the following is an example of a multi-band device?
- Question #29
Which one of these vertical market facilities is most likely to require a high density deployment?
- Question #30
What is the maximum data rate of the original 802.11 standard DSSS PHY (Physical Layer)?
- Question #31
When controller-based APs are used, where is the WLAN defined?
- Question #32
What must be defined in order to properly determine capacity requirements?
- Question #33
When an AP supports both 2.4 GHz and 5 GHz, what term is commonly used to define this AP?
- Question #34
What frequency band provides the most 20 MHz channels and is used by 802.11 devices?
- Question #35
When an AP is managed by connecting to it directly and it depends on no other device for operations, what kind of AP management system is in use?
- Question #36
In addition to coverage requirements, what primary requirements must be defined to ensure a WLAN performs as required?
- Question #37
What term is used to define the variance in delay or latency between packets on a network?
- Question #38
An AP offers a captive portal within the AP software. For what is this feature most likely to be used?
- Question #39
You must ensure Power over Ethernet (PoE) is available for new AP installations. What device can provide PoE power to the APs assuming it includes PoE support?
- Question #40
You are recommending a solution for a hospital environment. What room is most likely to require an AP inside the room to ensure coverage in that area because the walls block RF sig...
- Question #41
In a highly-reflective environment, what result can have a negative impact on SISO 802.11 devices?
- Question #42
Which one of the following is considered a data-intensive application?
- Question #43
What infrastructure software solution is often used to manage enterprise mobile devices?
- Question #44
Why would you need to know about neighbor 802.11 networks to create an effective WLAN implementation plan for a site?
- Question #45
What channel width rarely, if ever, should be used in the 2.4 GHz frequency band, even though it is supported by the standard and available devices?
- Question #46
RF waves are comprised of what two fields?
- Question #47
Why would you use external antennas for an AP mounted indoors?
- Question #48
What kind of antenna is most frequently used with indoor APs?
- Question #49
What becomes shorter as the RF wave frequency rises?
- Question #50
When planning for a bridge link between locations, in addition to the link distance, what requirement should be known in order to determine the antennas, settings and bridges to us...