What can cause excessive VSWR in RF cables used to connect a radio to an antenna?

Question

Options

• AHigh gain yagi antenna
• BRadio output power above 100 mW but below 400 mw
• CHigh gain parabolic dish antenna
• DImpedance mismatch

• B
  3% (1)
• C
  6% (2)
• D
  91% (29)

Explanation

Impedance is the measure of opposition to the flow of alternating current (AC) in a circuit. Impedance mismatch occurs when the impedance of the radio does not match the impedance of the antenna or the cable. This causes some of the transmitted or received signal to be reflected back, resulting in a loss of power and efficiency. The voltage standing wave ratio (VSWR) is a metric that indicates the amount of impedance mismatch in a transmission line. A higher VSWR means a higher impedance mismatch and a lower signal quality. A VSWR of 1:1 is ideal, meaning there is no impedance mismatch and no reflected power. A VSWR of 2:1 means that for every 2 units of forward power, there is 1 unit of reflected power. The other options are not correct because they do not affect the VSWR in RF cables. A high gain yagi antenna or a high gain parabolic dish antenna can increase the signal strength and directionality, but they do not cause impedance mismatch in the cable. Radio output power above 100 mW but below 400 mW is within the acceptable range for most WLAN devices and does not cause excessive VSWR in the cable.

No community discussion yet for this question.