CWDP-305 Exam Questions

A museum requires its wireless access points to be discreetly integrated into the environment without sacrificing performance. Which design choice best meets this requirement while...

An engineering firm upgraded from nine 802.11n APs to nine 802.11ac APs, retaining the same channel and power configuration. Despite this, throughput remains unchanged. What is the...

During a public Wi-Fi session with 10 other users, you run a ping sweep but cannot detect any devices on your subnet. What feature is likely enabled on the WLAN infrastructure to p...

While implementing 802.11ax APs in the 6 GHz band, a consultant recommends using WPA2- Personal for VoIP support. Why is this approach technically inappropriate?

While planning for a VoWLAN deployment requiring 25 dB SNR, you measure the noise floor at - 88 dBm. What is the minimum RSSI needed to meet the system's performance requirements?

When deploying an Enterprise-class VoWLAN infrastructure, which Access Category (AC) must be used to prioritize voice packets and ensure optimal performance?

When using a WLAN design tool with propagation modeling capabilities, what critical step must be performed before adding APs, antennas, and attenuation factors like walls?

Your customer's 802.11n laptops cannot detect the SSID in the 5 GHz band in a conference room, but your 802.11ac laptop connects without issue. What is the most likely explanation...

When designing a static channel plan for an office using voice devices near an airport, which range of channels may be avoided to avoid channel switching when implemented in this e...

Which vertically polarized antenna is best suited for a WLAN infrastructure with access points mounted on a ceiling over 6 meters high, where all client stations operate from the f...

When using a predictive design tool, you have selected access points (APs) with an antenna gain of 3 dBi and set the transmit power to 25 mW. What is the EIRP (Effective Isotropic...

Your customer has selected switches that support 802.3bz MultiGig interfaces and 4x4:4 802.11ac Wave 2 APs with dual-5GHz capabilities. The APs have one MultiGig interface, and som...

When conducting a site survey for a possible WLAN redesign, you use two Wi-Fi USB adapters for RSSI data collection and two USB spectrum analysis adapters for RF spectrum data. Sin...

What is the most cost-effective way to accurately measure the height of a ceiling when the use of a ladder is not permitted?

You conducted a site survey using two USB Wi-Fi adapters with a special driver designed for the site survey software. After deployment, the client devices show lower RSSI values co...

When performing an active site survey in an existing WLAN infrastructure, in addition to gathering throughput data, what other important function are you typically testing simultan...

Why should band steering algorithms allow stations to connect to the 2.4 GHz band after ignoring a certain number of Probe Requests?

After designing a WLAN infrastructure using predictive design software, what is the best way to validate the predictive design in the physical space before deployment, assuming tim...

Your customer requires a security solution where client credentials are used, not a Protected Access Credential (PAC), and the authentication server must have a certificate with op...

Your customer requires fast and secure roaming. Which two types of roaming are specified in 802.11 Fast Transition (FT) that will help meet this goal?

Which advantage provided by 802.11n and 802.11ac is not usable in 1x1:1 low-end client devices?

When deploying access points (APs) outdoors, which additional component needs to be used that is typically not required in most indoor office deployments?

Which document provided to your customer should include all devices and parts that will be used during the deployment of their WLAN infrastructure?

What limitation exists when WMM is not enabled on an 802.11 WLAN?

When designing for OFDMA, why might the same channel bandwidth result in greater efficiency than that available in 802.11n and 802.11ac?

What service must be implemented on your customer's network to authenticate users against an LDAP database before granting access to the WLAN infrastructure?

What is the best method of gathering attenuation measurements from wall materials?

Which type of authentication and encryption method is mandatory for Voice Enterprise certified devices as specified by the Wi-Fi Alliance?

Which document provides detailed instructions for installation technicians on how to properly mount and configure access points (APs)?

In addition to a copy of your design, which tools should you provide to ensure the installation team correctly deploys access points (APs) in the specified locations within a multi...

When installing access points (APs) on high ceilings, what is the most common personal protective equipment (PPE) that should be used?

You are preparing to perform a site survey for a company that processes meat, but some areas are restricted due to high security. What should you do in order to proceed with the si...

Which DHCP option, when required, must be configured to help access points (APs) locate their wireless LAN controller (WLC) during deployment?

When deploying a new WLAN infrastructure using Power over Ethernet (PoE) to power the access points (APs), you find that a known good AP is not powering up. You connect your laptop...

During your first pre-deployment meeting with the deployment team, you hand out the full design documentation to everyone. What is your primary goal during this meeting?

You have performed a validation site survey after deploying a WLAN infrastructure in an All- Wireless- Office. One specific application is experiencing delays after transitioning f...

What deliverables should be provided to the customer after successfully implementing a WLAN infrastructure?

Who should be present from the customer side during the final meeting after successfully implementing a WLAN infrastructure?

During a validation site survey, you discover that some access points (APs) have been mounted above the ceiling due to an aesthetic request from the building architect. However, no...

According to IEEE 29148-2018, which of the following is a characteristic of a requirements set that is not a characteristic of an individual requirement statement?

In a convention center auditorium, you've received complaints about the WLAN performance. Currently, only two APs are installed, but they are supporting over 300 client devices sim...

In 802.11, clients are required to be calibrated for RSSI and SNR reporting to:

You have determined the best mounting locations for APs in a given installation. The facilities manager has asked you to change the locations for several APs due to aesthetic conce...

When deploying long-distance 802.11 bridge links (10 miles / 16 km), what parameter may be critical for improving data flow by reducing retries caused by the long distances?

One of your customers plans on providing wireless coverage to a warehouse facility. After performing an initial walkthrough, you collect the following information: The central part...

Which definition correctly describes the "local MAC" variation of the centralized WLAN architecture?

When a WLAN controller sends an 802.11 frame to a lightweight AP for transmission on the wireless medium, how does it mark the frame for 802.11 QoS priority?

When selecting a centralized WLAN architecture, what new problem may arise when you change the data forwarding model from centralized to distributed?

Which one of the following is an essential metric to measure when performing a survey and design for VoIP across WLANs?

In a manufacturing facility with highly reflective materials, you are planning an upgrade to your existing 802.11b WLAN implementation. You have chosen a dual- band 802.11n infrast...