CWAP-402 · Question #95
You have been asked to recommend a solution for protocol capture of 802.11 frames consisting of 3x3:3 802.11ac communications. The requirement specifies that you gain a general view of a coverage…
The correct answer is D. Install sufficient Aps so that an AP can be taken offline to perform protocol analysis as needed. See the full explanation below for the reasoning.
Question
You have been asked to recommend a solution for protocol capture of 802.11 frames consisting of 3x3:3 802.11ac communications. The requirement specifies that you gain a general view of a coverage area and does not require that you capture from specific user locations. The solution must be the least expensive practical solution possible that does not disrupt user access to the WLAN and it must be based on enterprise WLAN hardware. What solution would you recommend so that any coverage area could be monitored on demand?
Options
- AInstall laptop-based protocol analyzer near each AP
- BInstall Wireshark on the Aps natively to allow dynamic capture while serving clients
- CInstall the minimum number of Aps required for coverage and use these Aps for protocol analysis
- DInstall sufficient Aps so that an AP can be taken offline to perform protocol analysis as needed
How the community answered
(63 responses)- A3% (2)
- B10% (6)
- C5% (3)
- D83% (52)
Community Discussion
No community discussion yet for this question.