IBM
C4040-227 · Question #91
The administrator changed the number of virtual processors from 1 to 2 in the default_profile of an LPAR. The operator ran the cfgmgr command expecting to see 2 processors after that, but did not…
The correct answer is C. Shutdown and then activate the default_profile. See the full explanation below for the reasoning.
Question
The administrator changed the number of virtual processors from 1 to 2 in the default_profile of an LPAR. The operator ran the cfgmgr command expecting to see 2 processors after that, but did not see them. What action must be done to apply the changes?
Options
- AReboot AIX within the LPAR.
- BRun cfgmgr against the device sys0.
- CShutdown and then activate the default_profile.
- DEnsure the RSCT daemon is operative and run cfgmgr again.
How the community answered
(23 responses)- A4% (1)
- B9% (2)
- C83% (19)
- D4% (1)
Community Discussion
No community discussion yet for this question.