IBM
C2180-274 · Question #69
A solution implementer is considering the following active-standby configuration between two DataPower appliances: In a simulated power failure of Appliance 1 using this active-standby configuration…
The correct answer is B. Appliances in the active-standby configuration must be in the same network subnet and. See the full explanation below for the reasoning.
Question
A solution implementer is considering the following active-standby configuration between two DataPower appliances:
In a simulated power failure of Appliance 1 using this active-standby configuration in a sandbox environment, Appliance 2 did not take over the active interface. What could be causing this behavior?
Options
- AIt can take several minutes for the standby interfaces to be active in an active-standby
- BAppliances in the active-standby configuration must be in the same network subnet and
- CIn an active-standby configuration, the priority of Appliance 2 must be changed to 99 for the
- DThere might be a firewall between the two appliances which has not been configured to allow
How the community answered
(64 responses)- A11% (7)
- B81% (52)
- C3% (2)
- D5% (3)
Community Discussion
No community discussion yet for this question.