ACMP_6.3 Exam Questions
196 real ACMP_6.3 exam questions with expert-verified answers and explanations. Page 3 of 4.
- Question #101
In the above screen capture: The administrator notes that most of the configuration options are grayed out and have no action. What is the cause of the problem?
- Question #102
Which of the following are valid RAP operating modes?
- Question #103
An AP 105 was converted into a RAP. The RAP can authenticate its IPSec tunnel to a controller using which of the following methods? (Choose two)
- Question #104
The network administrator wishes to terminate the VPN encryption on the Aruba controller. When writing a firewall rule to accomplish the task of automatically moving the VPN traffi...
- Question #105
Refer to the following configuration segment for this item. ip access-list session anewone user network 172.16.1.0 255.255.255.0 any permit user host 172.16.1.1 any deny user any a...
- Question #106
A campus AP has been provisioned with a VAP in bridge forwarding and standard operation modes. Which of the following authentication types are supported? (Choose two)
- Question #107
When does a RAP's backup SSID begin broadcasting?
- Question #108
Which protocol does the Aruba controller utilize for controller redundancy?
- Question #109
With CPSec disabled, which tunnel protocol is used between APs and Controllers in an Aruba environment?
- Question #110
Which of the following are NOT valid RAP forwarding modes? (Choose two)
- Question #111
A client device associates with an SSID provisioned with 802.1X authentication. The client is set for LEAP authentication. EAP termination (AAA Fastconnect) is enabled on the contr...
- Question #112
The reusable Aruba Controller wizards are accessible in what way?
- Question #113
Masters communicate configuration information with locals using which tunnel type?
- Question #114
Which of the following licenses are consumed by Mesh APs advertising an SSIDs?
- Question #115
In a master-local controller scenario, where is the mobility domain defined?
- Question #116
What are aliases used for?
- Question #117
An access port has been placed in trusted mode. The Vlan on the port is in Untrusted mode. Which of the following statements is true?
- Question #118
With CPSec disabled, Aruba access points are Layer 3 connected to controllers using which protocol?
- Question #119
Which ARM feature addresses the issue of sticky clients by moving clients to associate to APs with better 802.11 signal quality?
- Question #120
Which of the following commands is most useful in showing the traffic of an individual user?
- Question #121
A port on a controller has been configured as untrusted. No wired access AAA profile or Global AAA profile is configured. When a user connects to that port which of the following s...
- Question #122
IEEE 802.11r provides support for which of the following:
- Question #123
Which command, when executed on a master controller, will show the APs connected to all controllers?
- Question #124
Referring to the diagram provided for this question, an employee brought an unauthorized AP from home and attached the LAN port to the cubicle Ethernet port. All Aruba APs and AMs...
- Question #125
Which of the following configurations can accept a VLAN pool? (Choose two)
- Question #126
An Aruba based network has a Master and four local controllers deployed. But one of the locals, a new installation, is not seen by the Master. What might be wrong? (Choose two)
- Question #127
Which actions does ARM (Adaptive Radio Management) perform? (Choose two)
- Question #128
ip access-list session anewone user network 10.1.1.0 255.255.255.0 any permit user host 10.1.1.1 any deny user any any permit Referring to the above portion of a Mobility Controlle...
- Question #129
Which of the following will occur if a master license server fails with no standby server present? (Choose two)
- Question #130
Which method is NOT supported to provision an Aruba campus AP?
- Question #131
When an Aruba 6000 controller has two M3 modules installed, for which uses may the modules be used? (Choose two)
- Question #132
What are the Airtime Allocation Policy options for Airtime Fairness? (Choose three)
- Question #133
Referring to the diagram provided for this question, an employee brought an unauthorized AP from home and attached it to the cubicle Ethernet port as shown in the diagram. The APs...
- Question #134
ip access-list session anewone user network 10.1.1.0 255.255.255.0 any permit user any any permit host 10.1.1.1 host 10.2.2.2 any deny A user sends a frame with the following attri...
- Question #135
When deploying Remote Mesh Portals, what is one of the purposes of the Mesh Private VLAN?
- Question #136
How is an AP redirected to a Local controller after DNS resolution returns the Master's IP address?
- Question #137
When configuring a server group containing 3 servers, a customer chooses 'fail through mode'. What other configuration option has to be enabled on the controller for this to work w...
- Question #138
Which describe "roles" as used on Aruba Mobility Controllers? (Choose two)
- Question #139
In the diagram provided for this question, the Aruba controller terminates one end of a GRE tunnel that carries wireless user traffic. Where does the other end terminate?
- Question #140
Which of the following could be used to set a user's post-authentication role or VLAN association? (Choose two)
- Question #141
Which of the following firewall rules allows a user to initiate an ICMP session to other devices? (Choose two)
- Question #142
Which of the following licenses can be included in the licensing pool for centralized licensing? (Choose three)
- Question #143
A client attaches to a secure jack interface set to untrusted. But when the client tries to access the captive portal page, the following message appears, "Web Authentication is no...
- Question #144
A wired device is connected to an untrusted port on a controller. How can a role be assigned to the device?
- Question #145
The screen captures above show the 802.1X authentication profile and AAA profile settings for a VAP. If machine authentication passes and user authentication fails, which role will...
- Question #146
Which of the following metrics does the ARM feature use to calculate the optimal channel and power level for Access Points? (Choose two)
- Question #147
By default, which CLI based remote access method is enabled on Aruba controllers?
- Question #148
A company purchased an indoor mesh deployment using the 620 controller and the AP 105 models, where 5 APs will be deployed on a floor to provide wireless internet access for users....
- Question #149
When creating a firewall rule on an Aruba controller, which parameter is optional?
- Question #150
How does the ARM Band Steering feature encourage 5GHz capable clients to move/connect to the 5GHz radios of Aruba APs?