The provisioning script automatically runs as part of the first boot-up of the Avaya Session Border Controller for Enterprise (SBCE). During this process you assign the Management IP address to the…

Question

Exhibit

Options

• AReady
• BProvisioned
• CRegistered
• DCommissioned

• A
  3% (1)
• C
  94% (32)
• D
  3% (1)

Explanation

After the provisioning script assigns the Management IP and the SBCE communicates with the EMS, it appears as Registered because it has announced its presence to the EMS but the administrator has not yet initiated the software installation - it's "checked in" but not yet built out.

Why the distractors are wrong:

• A. Ready - This implies the device is fully operational and available for use, which has not occurred yet at this stage.
• B. Provisioned - This sounds plausible but is not the actual status label used in the EMS workflow at this pre-install step.
• D. Commissioned - This status comes after a successful install; commissioning means the device has been fully deployed and activated.

Memory tip: Think of it like a new employee process - the SBCE first registers (shows up and signs in), then gets installed (onboarded/trained), and finally becomes commissioned (fully active on the job). The question asks about the very first check-in step, which is Registered.

No community discussion yet for this question.