Cisco
600-504 · Question #46
Refer to the exhibit. H1 cannot ping H2. You have a Cisco onePK application that allows you to apply an ACL matching traffic flow between H1 and H2, on the router interfaces. Which command do you…
The correct answer is C. show ip access-list dynamic. See the full explanation below for the reasoning.
Question
Refer to the exhibit. H1 cannot ping H2. You have a Cisco onePK application that allows you to apply an ACL matching traffic flow between H1 and H2, on the router interfaces. Which command do you enter from the CLI of each router to check if the ACL is applied on its interfaces?
Exhibit
Options
- Ashow ip access-lists
- Bshow ip access-lists interface interface
- Cshow ip access-list dynamic
- Dshow run | in ip access-list
How the community answered
(52 responses)- A10% (5)
- B2% (1)
- C81% (42)
- D8% (4)
Community Discussion
No community discussion yet for this question.