An administrator has defined these three SE Groups based on capacity: Small-Group, Medium- Group, and Large-Group. The operator is configuring a Virtual Service that needs to be placed on SE's in…

Question

Options

• ACreate the VS in Basic Setup mode, and override the default SE Group.
• BCreate the VS in Advanced Setup mode, and override the default SE Group in the Policy section.
• CCreate the VS in Advanced Setup mode, and override the default SE Group in the Advanced
• DCreate the VS in Basic Setup mode, and override the default SE Group in the Policy section.

• A
  7% (2)
• B
  4% (1)
• C
  85% (23)
• D
  4% (1)

Explanation

Option C is correct because overriding the SE Group for a Virtual Service requires Advanced Setup mode, which exposes the full configuration surface - including the Advanced tab where the SE Group assignment can be changed from the default. Basic Setup mode (options A and D) is a simplified wizard that deliberately hides advanced infrastructure settings like SE Group selection, so it cannot be used to accomplish this goal. Option B is wrong because even though it correctly identifies Advanced Setup mode, the SE Group override lives in the Advanced section, not the Policy section - Policy is where settings like HTTP policies, rate limiting, and security rules are configured.

Memory tip: Think "Advanced task = Advanced mode + Advanced tab." Any time you need to touch infrastructure-level settings (where the VS lives), you need both the Advanced Setup mode and the Advanced configuration tab - "Advanced × 2."

No community discussion yet for this question.